10. 2.4G operation notes
This is 2.4G frequency model product make of automatic address code. It uses digital
transmission mode and this prevents outside interference effective active and passive.
10.01 Matching code
Our products are well-matched in the factory, you do not need to match by yourself. But if you
are going to match the receiver with other transmitter, please follow the following steps:
1. Install the battery to 2.4G transmitter and shut it down.
2. Insert the matching lines to the channel BAT port of the receiver. (Figure 1)
3. Connect the receiver battery to any one of the channel port, at the same time, two LEDs are
flashing, this means the receiver is going to the match status.
4. Press and hold the button on the transmitter, and then switch on the power supply.
5. Observe the LED on the receiver, if found that the LED is not flash anymore and that means
successful matched. (This process about 10s.)
6. Release the match button on the transmitter, take out the match line.
7. Install the server and then test.
8. If the tests fail, please repeat the action above.
9. If the tests success, then insert the power supply port into BAT, match complete.
(Above operations are for reference. Different product has its own operation.)
Figure 1
10.02 Boot
1. Connect every part.
2. Switch on the power supply.
3. Connect the power supply.
4. Receiver LED light solid.
5. Finish and use.
