MAXSA 43218 User manual

Model 43218
Adjust a light head

Introduction
Do you have a our Battery-Powered Motion-Activated
Dual Head LED Security Spotlight (model 43218)? Do
you want to adjust the light heads so they are tighter
or looser? Luckily, they can be adjusted quickly with a
paperclip and a Phillips-head screw driver.
These instructions will guide you, step-by-step,
through the process of adjusting the light heads.

Lay the product on its side with
the loose head on top as shown
in the picture. Located the screw
head cover, shown here in the red
circle. This is a small rubber cover
that prevents moisture from
getting to the top of the screw
and causing rust.
Step 1: Locate Rubber Screw Cover

Unfold a paperclip and use the
end to poke the edge of the
rubber cover. Carefully slide the
end of the paperclip past the
rubber cover.
Then, press the paperclip against
the rubber cover and pull the
paperclip out. This should bring
the cover with it. You now have
access to the head of the screw.
Step 2: Remove Rubber Cover

To Make it Tighter
Use a Phillips-head screwdriver to
turn the screw in a clockwise
motion. Check the head to see
how it rotates and continue to
tighten until you reach the
desired point.
To Make it Looser
Use a Phillips-head screwdriver to
turn the screw in a counter-
clockwise motion. Check the head
to see how it rotates and
continue to loosen until you
reach the desired point.
Step 3: Adjust the Screw
Rely on premium home lighting by MAXSA if you’re looking for quality and efficiency.