MayPole Erde MP6812 Parts list manual

NOTE: TIGHTEN FIXINGS TO TORQUES
PRESCRIBED IN THE LIST OF TOOLS
90° BRACKET
TOOLS REQUIRED FOR ASSEMBLY. NOT PROVIDED
(M6)
(M8)
(M10)
WEAR GLOVES
DURING ASSEMBLY
LIMITED
Manufactured on behalf of
Maypole Ltd, Birmingham UK
www.maypole.ltd.uk
[email protected]
NUTS AND BOLTS CONTENT IN BOX B
MP6812

DO NOT FULLY TIGHTEN FIXINGS AT THIS STAGE
CLIP CABLES TO THE BEAM
FULLY TIGHTEN ALL FIXINGS
IN SECTIONS A-C
REMOVE
x1
x1
x1
M 12x70
12
M12
PRE-FITTED BOLT
TO DRAW BAR
INSERT BOLT
TO DRAW BAR

CHECK THAT THE BASE PANEL IS SECURELY CLAMPED
DOWN ON TO THE DRAW BAR
FULLY TIGHTEN FIXINGS IMMEDIATELY
FULLY TIGHTEN THE
WHEEL NUTS

DO NOT FULLY TIGHTEN FIXINGS IN SECTIONS G-J UNTIL INSTRUCTED TO DO SO

FIT THE 90º BRACKETS
INSIDE THE MUDGUARD
90º BRACKETS