5.
Turn the commode right-side up. Insert the backrest
(4) into the receptacles located on the back of the
commode frame by depressing the push pins and
sliding into place. The push buttons will “click” in
place when they are secure.
Note: The angle of the backrest should face outwards.
6. Attach the toilet seat (5) and cover (6) to the back
of the frame. The toilet seat hooks should fit inside
the hooks of the cover.
8. Assembled commode
7. Lower commode bucket into frame and return seat
to the down position.
1. Before use, adjust height of each leg to
your specific needs, making sure all legs
are at the same height. When desired
height is reached, lock legs into place by
aligning buttons into proper holes, per
illustration.
2. Be sure legs are locked into place by
pushing down on or by pulling legs.
ADJUSTING LEG HEIGHT
ADDITIONAL PRECAUTIONS
1. Toilet seat must be in down position before use.
Failure to do so may result in breakage of commode
and possible injury.
2. Do NOT install commode without first reading and
understanding this assembly and instruction sheet.
If you cannot understand these instructions, contact
a healthcare dealer or technical professional before
attempting to install. Otherwise, injury or damage
may occur.
3. Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO NOT
USE. Contact dealer/carrier for further instructions.
4. Make certain that the height-adjusting snap buttons
fully protrude through the same respective holes of
each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved.
5. Ensure ALL screws, nuts and/or bolts are tightened.
6. Check the rubber tips on the leg extensions for rips,
wear or if they are missing. Immediately replace
any or all if any of these imperfections exist.
7. All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.
8. Users with limited physical strength should be
supervised or assisted while using commode.
Weight Capacity: 350 lbs (158 Kg)
WARNING: This product can expose you to
bisphenol A (BPA), which is known to the State
of California to cause birth defects or other
reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
Technical support, replacement parts and warranty
information? Call 1-866-694-5085
General product questions? Call 1-800-777-4908
Distributed by McKesson Medical-Surgical Inc.
Richmond, VA 23233
PVN B0518
Made in China
For complete details, please visit
mms.mckesson.com/mckesson-brands.
