McLelland AMP-D25MC User manual

OWNERS MANUAL
POWER MIC MIC VOLUME BASS TREBLE VOLUME
MIN MAX MIN MAX MIN MAX MAXMIN
AMP-D25MC
AMP-
D25MC
MINI STEREO
AMPLIFIER WITH MIC INPUT
CLASS D

2

AMP-D25MC is an ideal solution for residential and commercial audio installations that require a
simple setup and great sound output. With a small footprint, but high
output, these Class D amplifiers can sit on a desktop, or can easily be mounted on a wall or
within a rack using the included mounting brackets. The amps can be used in a stereo system,
but can also be switched for use in bridged or mono applications. The inputs consist of two
stereo audio inputs, two RCA inputs and a single 3.5mm input on rear panel, and a Microphone
input on front panel. Also includes an auto-ON feature so the unit does not need to be powered
manually, just hit play and the amp will power on automatically.
INTRODUCTION
FEATURE
SPECIFICATIONS
* Class D Digital Amplifier
* RCA and 3.5mm Jack Stereo Inputs
* Mixes two audio input sources together
* Stereo and Mono/Bridge Modes
* Microphone Input on the front panel with Volume control
* Treble/Bass Control on the front panel
* Automatically goes into standby after 5 minutes of inactivity
* Source Sensing to active the amplifier from standby mode
* AC 100~240V Power IN
• Output Power: Stereo (8 ohm): 25W per channel, <1% THD+N
Stereo (4 ohm): 45W per channel, <1% THD+N
Bridged Mono (8 ohm): 90W, 1kHz, <1% THD+N
• Frequency Response: 20Hz ~ 20kHz, -2dB/ +1dB
• Bass Adjustment: +/-12dB @ 100Hz/0dB
• Treble Adjustment: +/-12dB @ 10KHz/0dB
• Signal to Noise Ratio: 90dB below 25W output into 8 ohms
•Channel Separation: 48dB @ 1kHz, to 25W output at 8 ohms
• Input Sensitivity: RCA: 600mV
MIC: 20mV
• Input Voltage: AC 100V ~ 240V
• Net Weight: 1.37lbs/621g
• Dimensions: 1.77”/(45mm) x 5.62”/(143mm) x 4.92”/(125mm) (HxWxD)
3

FRONT PANEL
REAR PANEL
1
1
2
2
3
3
4
4
56 7
STEREO
BRIDGE
OUTPUT
INPUT
L
L
R
R
4/8Ω
AC IN: 110V - 240V, 50/60Hz 60W
+
4/8Ω
1. Power Switch
To Turn on the amplifier.
2. LED indicator
Green: Power On
Red: Standby mode
3. Microphone Input:
6.3mm input jack, please use dynamic
type of microphone.
1. 3.5mm Jack Stereo Input
2. RCA Stereo Input
Note: 3.5mm and RCA Stereo inputs will
mix the signal together. The Microphone
on the front panel will be mixed as well but
it has independently volume control.
4. MIC Volume
Adjusts the output volume of connecting
microphone.
5. Bass Control : +/-12dB
Adjusts the Bass of master output.
6. Treble Control: +/-12dB
Adjusts the Treble of master output.
7. Volume Control
Adjusts the Volume of master output.
3. Speaker Output Screw Connector
(Stereo/Bridge)
4. AC Power Input
Non-polarized C7/C8 coupler of figure 8
connector, AC 110V ~ AC 240V.
POWER MIC MIC VOLUME BASS TREBLE VOLUME
MIN MAX MIN MAX MIN MAX MAXMIN
AMP-D25MC
4

CONNECTION DIAGRAM
STEREO
BRIDGE
OUTPUT
INPUT
L
L
R
R
4/8Ω
AC IN: 110V - 240V, 50/60Hz 60W
+
4/8Ω
POWER MIC MIC VOLUME BASS TREBLE VOLUME
MIN MAX MIN MAX MIN MAX MAXMIN
AMP-D25MC
5
MIC input
DVD