Medeli DD403 User manual

1Check the include items
Setup Guide
CYMBAL PADS BOX
Cymbal Pad x 1
for Hi-Hat
Cymbal Pad with choke x 2
for Crash & Ride
DRUM PADS BOX DRUM MODULE BOX
ACCESSORIES BOX
BASS DRUM PEDAL BOX
HI-HAT PEDAL BOX
Owner’s Manual
Drum Key
Setup Guide
AC Adaptor
Connection Cable X 9
Hexagon Key
WARNING:
Drum key can be pinched when adjusting clamps with drum key. Operate carefully.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Snare Pad x 1
Cymbal Holder x3 Drumsticks Handscrews x 2

2Attach the Parts
Attach the Pads
1
2
1.Loosen wing nut on the holder
clamp, which is on the center
pipe(1),side arm(L2)and side
arm（R）.
2.Attach drum pads to the holder
clamp on center pipe(1),side
arm(L2),side arm(R) and tighten
wing nuts. Repeat for each pad.
Wing Nut
Attach the Cymbal Pads
1. Remove the wing nut and felt
washer from the cymbal tilter.
2. Place the cymbal pad, felt
washer, wing nut 3 assembly as
shown, and tighten the wing nut
3 to obtain an appropriate
amount of sway.
3. Adjust the cymbal pad position
with the wing nut 4.
Wing Nut 3
Felt Washer
Wing Nut 4
Cymbal Tilter
32
Assemble the Kick
1. Insert the beater to the beater holder on
the foot pedal.
2. Adjust the beater position and tighten
the beater with the drum key.
3. Attach the foot pedal to the kick pad.
4. Adjust the beat position and tighten the
wing nut.
Note:
Position the one beater in the center
of the kick pad kick .
123
4
Wing Nut
Center Pipe(1)
Side Arm(L1)
1
1
2 2
Side Arm(L2)
22
1
Side Arm(R)
Center Pipe(2)
1
Pillar(L) Pillar(R)
Hi-Hat
Crash
Ride
1

Attach the Drum Module
1
2
1. Connect the cable to the drum module as shown with
hands crews.
2. Attach the drum module to the mount holders on Side
Arm (L1), and firmly tighten the relevant wing nut.
Note:
Adjust the drum module position by moving the mount
holders as needed, and firmly tighten the relevant wing
nut.
Connection Procedure
1. Place the kick on the floor in the center of the rack as
shown.
2. Place the hi-hat pedal on the floor on your left side.
3. Connect the pads to the drum module with the marked
cables.
Are you ready? Let's enjoy playing it.
3Connect the Pads to the Drum Module
3
Hi-Hat
Drum
Module
Ride
Kick
Hi-Hat
Pedal
Make connections as shown in the illustration.
Tom 3
3
Crash
Tom2Tom1
Snare Tom3
Drum Module
Drum Pad
Cymbal Pad
PedalHi-Hat
To
control
Hi-Hat
To Kick
Tom 2To
Tom 3To
SnareTo
Tom 1To
Kick Pad
Hi-HatTo
To Crash
RideTo