Medeli DD514 User manual

1Check the include items
Setup Guide
CYMBAL PADS BOX
Cymbal Pad for Hi-Hat Cymbal Pad for Crash1
(with Choke)
Cymbal Pad for Ride
DRUM PADS BOX
KICK PEDAL BOX
STAND AND CYMBAL HOLDER BOX
Pillar (L1) Pillar (R1) Pillar (L2) Pillar (R2)
Center Pipe (1)
Center Pipe (2)
Side Arm (L1)
Side Arm (L2)
WARNING:
Drum key can be pinched when adjusting clamps with drum key. Operate carefully.
Be careful around pipe ends, inside the pipe and screw ends. Metal shavings, etc. May injure your fingers.
Cymbal Holder(L)
Side Arm (R)
Cymbal Holder (R) X 2
1~3
DRUM MODULE BOX
HI-HAT PEDAL BOX
ACCESSORIES BOX
Hi-Hat Holder Drumsticks
Owner’s Manual
AC Adaptor
Pad Mount X 5
Drum Key
Handscrews X 2 Connection Cable X 11
Setup Guide
Hexagon Key
EXTENDED PADS BOX
Cymbal Pad for Crash2
(with Choke)
4

2Set Up the Stand
Pillar (L1)
Center Pipe (1)
Center Pipe (2)
Pillar (R1)
1. Attach the Center Pipe (1) to the clamp on the Pillar (L1).
2. Attach the Center Pipe (2) to the clamp on the Pillar (L1).
3. Attach the Center Pipe (1) & (2) to the clamps on the Pillar (R1).
4. Attach the Side Arm (L1) to the clamp on the Pillar (L2).
5. Attach the Side Arm (L1) to the clamp on the Pillar (L1).
6. Attach the Side Arm (R) to the clamp on the Pillar (R2).
7. Attach the Side Arm to the clamp on the Pillar (R1).
8. Attach the Side Arm (L2) to the clamp on the Pillar (L1).
Note:
Loosen or tighten the screws on the clamp with drum key as shown partial enlargement.
Adjust the height of the Side Arms with drum key as needed.
(R)
123
Side Arm (L1)
Pillar (L2)
Pillar (R2) Side Arm (L2)
45
678
Wing Nut 1
Wing Nut 2
9. Attach the pad mounts to the mount holders on
the Center Pipe (1), Side Arm (L2), Side Arm ,
and firmly tighten the respective wing nuts 1.
Note:
Loosen or tighten the wing nuts on the mount
holder as shown partial enlargement.
Move the mount holders as needed, and firmly
tighten the respective wing nuts 2.
(R )
10. Insert the two cymbal holders into the holders on
the Pillars, attach the hi-hat holder to mount
holders on the Side Arm (L1), and firmly tighten
the respective wing nuts .
Note:
Loosen or tighten the wing nuts on the mount
holder as shown partial enlargement.
9 10
(R)Side Arm

3Attach the Parts
Attach the Pads
1
2
1. Loosen the wing nuts on the drum pads.
2. Attach the drum pads to the pad mounts,
and firmly tighten the wing nuts on the
drum pads.
Wing Nut
Attach the Cymbal Pads
1. Remove the wing nut and felt
washer from the cymbal tilter.
2. Place the cymbal pad, felt
washer, wing nut 3 assembly as
shown, and tighten the wing nut
3 to obtain an appropriate
amount of sway.
3. Adjust the cymbal pad position
with the wing nut 4.
Note:
Tightentheboltwiththe
hexagonkey asshown
partial enlargement
Wing Nut 3
Felt Washer
Wing Nut 4
Cymbal Tilter
1
2
Assemble the Kick
1. Insert the beater to the beater holder on
the foot pedal.
2. Adjust the beater position and tighten
the beater with the drum key.
3. Attach the foot pedal to the kick pad.
4. Adjust the beat position and tighten the
wing nut.
Note:
Position the one beater in the center
of the kick pad or the two beaters
equally apart from the center of the kick
pad as shown.
123
4
Wing Nut
Put the cymbal on the cymbal
adapter and locate the tap of
the adapter in the slot ofthe
cymbalbottom
Slot
Tap
3
Tom 2Tom 1
Tom 4
Snare
Ride
Crash 1
Hi-Hat
Hexagon
Key
Tom 3
Crash 2

Connection Procedure
1. Place the kick on the floor in the center of the rack as
shown.
2. Place the hi-hat pedal on the floor on your left side.
3. Connect the pads to the drum module with the marked
cables.
Are you ready? Let's enjoy playing it.
Make connections as shown in the illustration.
4Connect the Pads to the Drum Module
DD514_G05
Attach the Drum Module
1
2
1. Connect the cable to the drum module as shown with
handscrews.
2. Attach the drum module to the mount holders on Side
Arm (L1), and firmly tighten the relevant wing nut.
Note:
Adjust the drum module position by moving the mount
holders as needed, and firmly tighten the relevant wing
nut.
Ride
Crash 1
Hi-Hat
Drum Module
Snare
Tom 4
Hi-Hat Control Kick
Tom 1 Tom 2
Tom 3
Crash 2
Crash 1 Ride
Hi-Hat
Drum
Module
Snare
Tom3
Tom4
Tom1 Tom2
Kick
Hi-Hat
Pedal
Tom 4
Crash 2