Mellanox Technologies SX6015 User manual

www.mellanox.com
Mellanox InfiniBand
1U Switch Systems
Quick Installation Guide
Models: SX6015, SX6018, SX6025, SX6036,
SX6036G

2
Pay Attention!
• All servers and systems in the rack should be planned with the airflow
direction. All FRU components must have the same air flow direction. A
mismatch in the air flow will affect the heat dissipation.
• The FRUs are extractable. The rails should be attached to the ports side
of the system, so this side is adjacent to the cabinet. This will allow you
to slide the FRUs, in and out.
Package Contents
•1xSystem
• Rail Kit for short depth (17”-24” / 432-610mm) or standard depth (24”-
34” / 610-863mm) racks
• 1or 2 (according to order) x Power cables – Type C13-C14
• 1 x Harness RS232 2M cable – DB9 to RJ-45 (for managed systems
only)
•QuickStartGuide
If anything is damaged or missing, contact your Mellanox representa-
tive at [email protected].

3
Package Contents
10X 10X
16X*
1X
1X 1/2X**
2X 2X
2X
* 14X screws for use + 2X spare units
**According to customer order

Mellanox Technologies 5
1
2

Mellanox Technologies
6
3
4

Mellanox Technologies 7
5

8
Connector (Front) Side
Externally Managed Systems
FRU (Rear) Side
* It may take up to five minutes to turn on the system. If the System Status LED shows red after
five minutes, unplug the system and contact your Mellanox representative.

9
LED Assignments
Configuration
For full installation instructions, go to http://www.mellanox.com/-->Products-->
InfiniBand/VPI Switch Systems