MetaSystem M357 TV3 User manual

User Manual
Hereby, Meta System S.p.A. declares that Remote control type Mykro is in compliance
with Radio Equipment Directive 2014/53/EU.
Frequency Bands in which the radio equipment operates:
433.05 MHz – 434.79 MHz <10mW e.i.r.p.
Certificate Holder’s Address:
Meta System S.p.A. - Via Galimberti 5, 42124 Reggio Emilia (Italy)
The full text of the EU Declaration of Conformity is available at the following internet
address: https://docs.metasystem.it/
SIMPLIFIED EU DECLARATION OF CONFORMITY
M357 TV3

Alarm STATUS LED DIRECTION
INDICATORS SIREN
Arming by remote control Button A Slow  ashing 2 Flashes 2 BEEP
Arming without tilt sensor, A then B Slow  ashing Flashes 2 + 1 2 BEEP + 1 BEEP
Arming with panel open Slow  ashing 2 Flashes 2 BEEP + 1 BOOP
Initial immunity phase Fast  ashing
Testing during the initial immunity phase Fast  ashing 1 BEEP with
each trigger
Alarm armed Slow  ashing
Alarm Triggered Switches o Flashing Sounds
Disarming by remote control Button A Switches o 1 Flash 1 BEEP
Disarming when the motorcycle’s
battery is fl at Switches o 4 BEEP
Disarming when alarm triggers
have been memorised
Switches o brie y
every 6 sec. 1 BEEP + 1 BOOP
Pre-alarm phase Switches o 5 BEEP
Service Mode Flashing very fast
with ignition key ON
The LED will signal the trigger cause. If various alarms have been triggered, the memory will signal
them in a sequence with 3 seconds pauses and will repeat the sequence every 6 seconds. The
memory is reset when the ignition is switch ON or the alarm system is armed with the remote
control again.
MEMORISED ALARMS LED SIGNALS
Internal movement sensor 1 Flash
Contacts 2 Flashes
Ignition key sensing 3 Flashes
Tampering with cables or battery 4 Flashes
BUTTON A
BUTTON B
The immobiliser arms automatically 50 seconds after ignition OFF, signalled by a short flash of
the direction indicators and a slow flashing of the LED.
2.. PASSIVE ARMING of IMMOBILISER
3..Alarm Memory

The alarm protects the motorcycle against being started and an alarm cycle will be triggered
every time:
• The ignition key is turned ON
•An attempt is made to remove a protected panel (for example if the seat or the storage
compartment is opened...)
•The motorcycle is moved
•The alarm power suppy is disconnected
4.PROTECTION
5.PANIC Function
It is possible to trigger a 10 second alarm cycle by pressing the B button on the remote control.
This alarm cycle can be interrupted by pressing the same button again.
To enable the SERVICE MODE turn ON the ignition and immediately after press hold the A
button of remote control for at least 6 secs; confirmation of mode ON is indicated by the
LED fl ashing quickly when the ignition ON.
To disable the SERVICE MODE turn ON the motorcycle’s key and immediately after press hold
the A button of remote control at least 6 secs; confirmation of mode ON is indicated by the LED
being off when the ignition ON.
Deep Sleep Mode is activated 5 days after the system was armed. The alarm protection remains
active but the remote receiver is switched off.
To exit from DEEP SLEEP MODE, turn the ignition key ON: the siren will emit a series of BEEP
sounds. Press the remote control within 20 seconds of the BEEPS to disarm the alarm system. If
the remote control is not pressed within 20 seconds, an alarm cycle will be triggered.
6. SERVICE MODE
7. DEEP SLEEP MODE

If a remote control is lost, stolen or damaged, it is possible to disarm the alarm system with a 5
digit emergency code.
Perform the following procedure.
Switched the ignition ON then OFF; the LED will turn ON, turn OFF and then start to fl ash after 2
seconds.
8. ‘OVERRIDE’ EMERGENCY CODE
DISARM
OK
x1 x3 x2 x1 x2
ALARM
IN ACTIVE
PHASE
(AFTER 26 SEC.)
“OVERRIDE”
EMERGENCY CODE
2 SEC.
3 QUICK
FLASHES
CONFIRM
3 QUICK
FLASHES
CONFIRM
3 QUICK
FLASHES
CONFIRM
( WITHIN 2 SEC. )
WITHIN 10 SEC. WITHIN 10 SEC. WITHIN 10 SEC. WITHIN 10 SEC.
Power supply .......................................................................................................12Vcc (10V-15V)
Consumption .........................................................................................................................1,0 mA
Consumption in DEEP SLEEP MODE ............................................................................. 0,3 mA
Operating temperature ..........................................................................................- 25°C + 85°C
Sound level of siren ..............................................................................................................114 dB
Self-supply autonomy ...................................................................................................5 minutes
Remote controls ...................................72 million billion variable codes (lithium battery)
Sensitivity of internal movement sensor .....................................................1,5° per second
Frequency of Mycro remote control .....................................................................433.92 MHz
9. SPECIFICATIONS
Initial immunity phase ...............................................................................................26 seconds
Duration of alarm cycle ...............................................................................................26 seconds
Interval between alarm cycles/No .......................................................................5 seconds/10
Passive arming delay ...................................................................................................50 seconds
DEEP SLEEP MODE delay ..............................................................................................5 days
Frequency of direction indicators .......................................................0,4 sec.Off /0,4 sec.On
10.TIMINGS