Metra Electronics 99-3528 User manual

INSTALLATION INSTRUCTIONS FOR PART 99-3528
86-3528 Radio Removal Keys • Flat Blade Screwdriver • Phillips Screwdriver
KIT FEATURES
•DIN Head Unit Provisions with Oversized Pocket
A) Radio Housing
KIT COMPONENTS
TOOLS REQUIRED:
99-3528
A
APPLICATIONS
2004-2006 Pontiac GTO

99-3528
Disconnect the negative battery ter-
minal to prevent an accidental short
circuit.
1
Using the radio removal keys, pull
the factory head unit from the dash
and disconnect the wiring.
(Figure A)
2
A
2004-2006 PONTIAC GTO
Unsnap and remove the trim panel at
the top center of the dash above the
A/C vents and remove (4) Phillips
screws. (Figure B)
3
Remove (1) Phillips screw from
inside lower open storage area
where center console and dash
meet.
(Figure C)
4
B
C
Unsnap and remove center console
(open center armrest/ storage com-
partment and work forward).
(Figure D)
5
D
DASH DISASSEMBLY

99-3528
DASH DISASSEMBLY (cont’d)
2004-2006 PONTIAC GTO
Remove (2) Phillips screws exposed
at the bottom of the center panel
surrounding radio and remove panel.
(Figure E)
6
E
Unclip and remove trim panel sur-
rounding radio and A/C controls.
7
Remove (3) Phillips screws holding
"cage" in radio opening.
(Figure F)
8
Pull down on the "cage" from the
opening inside on the top and
remove. (Figure G)
9
F
G

99-3528
KIT ASSEMBLY
Slide the DIN cage into the Radio
Housing and secure by bending the
metal locking tabs down.
(Figure A)
1
A
Slide the aftermarket head unit into
the cage and secure. (Figure B)
2
B

99-3528
FINAL ASSEMBLY
1
Locate the factorywiring harness
in the dash. Metra recommends
using the proper mating adapter
and making the connections as
shown. (Isolate and individually
tape off the ends of any unused
wires to prevent electrical short
circuit)
2
Re-connect the negative battery
terminal and test the unit for
proper operation.
3
Reassemble in reverse order of
disassembly leaving the cage
(removed in step 9 of dash disas-
sembly) out and snapping the 99-
3528 in place of the factoryradio.
A
A) Strip wire ends back 1/2"
B) Twist ends together
C) Solder
D) Tape
B
C
D
METRA ACCESSORIES STEREO DASH KITS