Metra Electronics 99-5025 User manual

KIT COMPONENTS
Equalizer
Dummy
Plate
(4) Phillips Oval-
head Screws
Rear Support
Bracket
KIT FEATURES
Shaft and
DIN unit
provisions
Equalizer
provisions
Radio Housing
99-5025
INSTALLATION
INSTRUCTIONS
APPLICATIONS
CAR PAGE
FORD
Mustang 1987-93.....................................................1-2
TOOLS REQUIRED
Cutting tool
Phillips screwdriver
86-5618 - Head unit
removal keys
1-800-221-0932 www.metraonline.com
© COPYRIGHT 2001 METRA ELECTRONICS CORPORATION
rev. 030701

12
4 5
Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adaptor and making
connections as shown. (Isolate and
individually tape off the ends of any
unused wires to prevent electrical short
circuit).
Re-connect the battery terminal and test the unit
for proper operation. Mount the Rear Support
Bracket to the back of the unit. Mount the head
unit/kit assembly to the sub-dash with (4) Phillips
Oval-head Screws supplied. (Be sure the Rear
Support Bracket engages the support shelf in the
dash).
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Disconnect the negative battery terminal to prevent an accidental short circuit. Using Metra's
86-5618, pull the factory head unit from the dash and disconnect the wiring.
1
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the kit and secure with shaft
nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports from the Radio Housing. Slide the
DIN cage into the Housing and secure by bending the metal locking tabs down. Slide the
aftermarket head unit into the cage until secure. (see Fig. B)
IF AN EQUALIZER WILL BE INCLUDED: Slide the aftermarket equalizer into the back of the
Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit.
(see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the
Radio Housing. (see Fig. B)
2
3
Fig. A
Fig. B
Fig. A
ALL VEHICLES
Fig. B