Metrologic MS9530 Series User manual

MS9530 Voyager RF Quick Configuration guide 1Printed: December 2002
Version: 1.0 Status:Approved

MS9530 Voyager RF Quick Configuration guide 2Printed: December 2002
Version: 1.0 Status:Approved
QUICK CONFIGURATION GUIDE
1.- Link MS9530 Voyager RF with Base Station.
-Please read the following barcodes in the required order to fix Voyager RF interface and
complete linking:
1º.-
Enter configuration
2º.- (*) Skip this step if you just want to change the link to another
Base station.
Following parameters are set:
-Base Station serial number :9999999999
-Voyager ID: 1
3º.- Ready to read the new Serial number of Base Station to
send data to.
4º.-
Read Base Station
serial number.
5º.-
Exit Configuration
(Unit should re-start and link with Base Station)

MS9530 Voyager RF Quick Configuration guide 3Printed: December 2002
Version: 1.0 Status:Approved
2.- MS9530 Voyager RF ID:
- Up to five units can work together with same Base Station. It is requested that each of them
uses a different ID. Use this section to fix the desired Identifier into Voyager RF.
3.- WEDGE BASE STATION Minimum configuration: PC connection
-Please read the following barcodes in the required order:
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-

MS9530 Voyager RF Quick Configuration guide 4Printed: December 2002
Version: 1.0 Status:Approved
3.- RS-232 BASE STATION Minimum configuration ( 9600,8,N,1, CRLF)
-Please read the following barcodes in the required order :
1º.-
2º.-
3º.-
4º.-
5º.-
6º.-
7º.-
8º.-
9º.-