MGA Entertainment BRATZ RC Hoverboard User manual

F.
D.
E.
1
4
SKU: 545613 / 545620
Illustrations are for reference only. Styles may vary from actual contents.
CONTENTS
A. 1 Doll with Fashion
CloeTM (545613) OR YasminTM (545620)
B. 1 Pair of Doll Shoes
C. 1 Pair of Earrings
D. 1 Pair of Doll Knee Pads
ADULT SUPERVISION AND BATTERY INSTALLATION REQUIRED
5+ YEARS
FCC COMPLIANCE
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential
installation.This equipment generates,uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Warning:Changes or modifications to this unit not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
E. 1 Pair of Doll Elbow Pads
F. 1 Doll Helmet
G. 1 Hoverboard for Doll
(CloeTM: 27 MHz,YasminTM: 49 MHz)
H. 1 Remote Control
I. 1 Doll Stand
• Use alkaline batteries for best performance and longer life.
• Use only the type battery recommended for the unit.
• Batteries should be replaced only by an adult.
• Insert batteries with the correct polarity ( + and – ).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable(nickel-cadmium) batteries.
• Do not short-circuit batteries.
• When not used for an extended time, remove batteries to prevent possible leakage
and damage to the unit.
• Do not mix rechargeable and non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before charging.
• Rechargeable batteries are to be recharged only under adult supervision.
• Do not recharge non-rechargeable batteries.
• Exhausted batteries are to be removed from the toy.
• Do not dispose of batteries in fire as they may leak or explode.
SAFE BATTERY USAGE
A.
B.
C.
I.
G.
H.
Please keep this manual as it contains important information.
The preferred method of contact for
Customer Service is through our e-mail
contact form at www.mgae.com
0516-0-E
www.bratz.com
© MGA Entertainment, Inc.
BRATZILLAZ™, BRATZ® and BRATZ BOYZ® are trademarks of MGA
in the U.S. and other countries. All logos, names, characters,
likenesses, images, slogans, and packaging appearance are the
property of MGA.
16300 Roscoe Blvd.
Van Nuys, CA 91406 U.S.A.
[phone]
Printed in China
Visit
.com
to register your product
and to enter our sweepstakes
(No purchase necessary)
‘Let’s care for the environment!’
The wheelie bin symbol indicates that the product must not be disposed of with other household
waste. Please use designated collection points or recycling facilities when disposing of the item.
Do not treat old batteries as household waste. Take them to a designated recycling facility.
RC Hoverboard
A.
B.
C.
CloeTM (545613) OR YasminTM (545620)

223
IMPORTANT INFORMATION
1. Using a Phillips screwdriver (not included) remove the
screw and battery compartment cover from the
underside of the hoverboard.
2. Install three (3) fresh 1.5V AAA alkaline batteries (not
included) making sure the (+)and (-) ends face the
proper direction as indicated inside the battery
compartment.
3. Replace the compartment cover and tighten the screw.
BATTERY INSTALLATION
Before playing, an adult must install fresh alkaline batteries in the HOVERBOARD and REMOTE.
HOVERBOARD
REMOTE CONTROL
1. Using a Phillips screwdriver (not included) remove the
screw and battery compartment cover from the back
side of the remote.
2. Install two (2) fresh 1.5V AAA alkaline batteries (not
included) making sure the (+) and (-) ends face the
proper direction as indicated inside the battery
compartment.
3. Replace the compartment cover and tighten the screw.
IMPORTANT NOTE:
In the event of a malfunction, reset the item by removing and replacing the batteries. If function is still not
restored, replace the batteries with fresh alkaline batteries.
QUICK START
• Only one hoverboard of the same MHz can be used at a time. Purchase a CloeTM and YasminTM hoverboard to play at the
same time.
• The hoverboard must remain in remote control range to operate correctly.The range depends on the surrounding area and
on the strength of the battery. Obstructions such as buildings, fences, etc., between the remote control transmitter and the
hoverboard reduce the range.
• Your Bratz® remote control hoverboard is controlled by radio frequency. It may interfere with nearby devices such as
cordless phones,radios, walkie-talkies, or other radio controlled devices.If this occurs, move the hoverbaord to a location
away from the interference.
• If the doll comes with a jacket or vest, remove it before attaching the elbow pads.
• Always turn the hoverboard and the remote to the“OFF” position after playing to conserve battery power.
• Do not use the unit in the street, anywhere there is vehicular traffic, or in heavily traveled pedestrian areas.
• Do not stand or sit on or throw the unit as doing so can result in injury to the person and damage to the unit.
• Do not run the hoverboard into furniture, walls,pets, people etc., as doing so may cause injury to the people and pets and
irreparable damage to the unit.
• Keep long hair and loose apparel such as shoestrings away from the turning wheels of the hoverboard.
• Do not drive the hoverboard through water or mud.
• Use on a flat, level surface.The unit operates on some low-pile carpet, but best performance is achieved on smooth flooring.
• Do not expose the hoverboard or remote to moisture of any kind.
• DO NOT wash doll’s hair with water and/or soap.
• DO NOT dry doll’s hair with a hair dryer or subject hair to very high heat in any manner.
• DO NOT operate this hoverboard during thunderstorms.
The batteries included in the hoverboard are for in-store
demonstration purposes and should be replaced before use.
Here’s how:
1 2
3
5 6
Turn ON the remote. Move the switch on the hoverboard
from“TRY ME”to “ON.”
Insert the doll stand into the opening
on top of the hoverboard.
Place the dolls shoes on the pegs on top of
the hoverboard and connect the doll’s waist
to the doll stand.
Press the or button to move
the hoverboard forward or in reverse.The
lights on the hoverboard light up while
the hoverboard is in forward motion.
Press the or button to spin to
the left or spin to the right.The left or
right light on the hoverboard will light
up in the direction you are turning.
1.5V AAA / LR03
1.5V AAA / LR03
1.5V AAA / LR03
1.5V AAA / LR03
1.5V AAA / LR03
4