Miboxer WL-433 User manual
Model No.: WL-433
433MHz Gateway
Use LoRa SPSP Modem technology, compatible with
MiBoxer 433MHz series products; and controlled by
MiBoxer APP through WiFi or 4G network. Support
DMX512(1990) control. Support third party voice control.
1. Features
2. Parameters
WiFi
Wireless Control
WiFi
433MHz RF
LoRa SPSP modem technology
433MHz
Support DMX512(1990)
control
Dimmable
Saturation control
Smart phone
App control
Support Third Party
Voice Control
Timing ON/OFF
the lights
16 Millions of colors
to choose
Color temperature
2700-6500K
Please read the instructions carefully
before using the controller.
Can control MiBoxer 433MHz
series product
3. Installation
Please install the device within 50m as lights, and
approaching the WiFi Router.
Subordinate New Brand
One button learning
Copy remote ID
Model No.: WL-433
Input: DC5V/500mA ( 5.5*2.1mm )
Working Temperature: -20~60℃
Communication Mode: WiFi-IEEE 802.11b/g/n 2.4GHz
Input Signal: DMX512(1990)
RF: 433MHz ( Transmitting Power: 15dBm )
Modulation Method: LoRa spread spectrum
Control Distance: 50m (Lamps into 0.5m under freshwater)
Control Distance: 1000m (Lamps on the open area)
Product Weight: 95g
48mm
182mm
27mm
118mm Φ30mm
DMX512
Control Panel
Power input DMX512
signal input
1. The input voltage is DC5V/500mA, Please do not
connect the power supply over DC5V, otherwise,
the device will be broken easily.
2. Non-professional user cannot dismantle the divice
directly, otherwise, the device will be broken easily.
3. The working temperature is -20~60℃; Do not install
the device to direct sunlight, moist and other high
temperature area.
4. Please do not install the device around the mental
area and high magnetic field, otherwise, it will
badly affect the control distance.
Made in China
Attention
4. User Instruction
Setting DMX512 address:
Zone selection:
1. Install MiBoxer APP. Click“ + ” add devices( See
details on MiBoxer APP instructions).
2. Click "433 Gateway" on the device list to enter
control interface.
3. Click "Link/Unlink". Link/Unlink method, See details
on APP link/unlink instruction.
4. After linking successfully, back to the control
interface to control the lights randomly.
Click "Set DMX" on the top right corner; Set DMX512
address for gateway on the pop-up window.
Click the "Zone" on the left bottom into the Zone selection.
Gateway copy the remote ID to fulfill the gateway and
remote ID no difference; after linking with remote, the
gateway can control the lamps directly without linking
again.
Short press gateway "SET" five times; restore
successfully after devices indicating lamp blink 3 times.
Learning function: Restore gateway ID:
1. click "Learn" button, device indicating lamp blinking.
2, within 10 seconds, click any button on the remote,
APP will hint learning successfully.
Note: Just FUT086 433MHz remote support learning
currently.
Note: Please select the linked Zone, otherwise it cannot
control the lamps.
Gateway need to occupy 5 address to control lamp's
red,green,blue,warm white and coor white accordingly.
i.e: Set the gateway DMX512 address to 008
Note: You must link the lamps to the gateway to control
the lamps(Linking instruction see details for Miboxer
APP Link/Unlink interface).
Note: This gateway cannot group control.
Mobile
10:18 95%
Device List
433 Gateway ON
Device Group Discovery
Mobile
Mobile
10:18 95%
433 Gateway
Set DMX
White LightZone1 Timer Link / Unlink
Mobile
Mobile
10:18 95%
433 Gateway
Set DMX
White LightZone1 Timer Link / Unlink
Mobile
Mobile
10:18 95%
433 Gateway
Set DMX
White LightZone1 Timer Link / Unlink
Mobile
White Light Timer Link / Unlink
Link/Unlink
Mobile
10:18 95%
Link / Unlink
Select zones
Zone1
Zone5
Zone2
Zone6
Zone3
Zone7
Zone4
Zone8
UnlinkLinkLearn
1. Please select linking channel
2. Switch of the light; after 10 seconds, switch on again.
3. Press the linking button once within 3 seconds.
4. Link is done when the light blink 3 times slowly.
Note: If the light doesn’t blink slowly, Linking is failed.
1. Please check if the light is compatible with the remote.
2. Check if the light has been linked; The linked light
cannot be linked again.
3. Please follow above steps to link again.
1. Please select the linking channel
2. Switch of the light; after 10 seconds, switch on again.
3. Press the unlinking button once within 3 seconds.
4. Unlink is done when the light blink 10 times quickly.
Note: If the light doesn’t blink quickly, Unlinking is failed.
1. Please check if the light is compatible with the remote.
2. Check if the light has been linked; The unlinked light
cannot be unlinked again.
3. Please follow above steps to unlink again.
Linking instruction:
Unlinking instruction:
Mobile
White Light Timer Link / Unlink
Link/Unlink
Mobile
10:18 95%
Link / Unlink
Select zones
Zone1
Zone5
Zone2
Zone6
Zone3
Zone7
Zone4
Zone8
UnlinkLinkLearn
1. Please select linking channel
2. Switch of the light; after 10 seconds, switch on again.
3. Press the linking button once within 3 seconds.
4. Link is done when the light blink 3 times slowly.
Note: If the light doesn’t blink slowly, Linking is failed.
1. Please check if the light is compatible with the remote.
2. Check if the light has been linked; The linked light
cannot be linked again.
3. Please follow above steps to link again.
1. Please select the linking channel
2. Switch of the light; after 10 seconds, switch on again.
3. Press the unlinking button once within 3 seconds.
4. Unlink is done when the light blink 10 times quickly.
Note: If the light doesn’t blink quickly, Unlinking is failed.
1. Please check if the light is compatible with the remote.
2. Check if the light has been linked; The unlinked light
cannot be unlinked again.
3. Please follow above steps to unlink again.
Linking instruction:
Unlinking instruction:
Cancel
Learning...Please press any button
on remote
Cancel OK
Set DMX512 Address
Current address：001
Please input number from 1~512
Occupied
address
Controlled
colors
008 009 010 011 012
Red Green Blue
Cold white Warm White
MiBoxer APP
User Instruction
For IOS System: Pls search "MiBoxer" on APP store. (Above
IOS9.0)
For Android System: search "MiBoxer" on Google Play (Above
Android 5.0) or Scan below QR-code to download APP.
APP Downloading
1
Open APP and click Register button;Complete the register and
log in.
Register MiBoxer Account
2
1. Click the right top “+” on the device list.
2. Please select the device type you will add, then complete
the adding according to the hint of APP.
3. Back to device list after adding successfully, then pull down
refresh in list to get the device status.
Add Device
3
Mobile
10:18 95%
Device List
Device Group Discovery
Slide device list to left, click " Edit " to modify device name;
click " Delete " to delete device.
Note: If the device was shared to others, then the device will
also be deleted on your friends' device list.
Modify device name or delete device
4
Scan QR Code to Install APP
Controller ON
Mobile
10:18 95%
Device List
Remote ON
Device Group Discovery
ON Edit Delete
Controller
WiFi Box ON
Gateway ON
Subordinate New Brand
Mobile
10:18 95%
Mobile number / Email address
Password
United Kingdom +44
Authentication code login
I agree Service Agreement and Privacy Policy
Log in
Register
Forgot Password
Click left top " " icon on the home page;
Then click " " to check detailed instructions.
Third Party Voice Control instructions
6
Share the device to friends, Let your friends can control this device.
1. Click the left top " " icon on the home page.
2.
Click " " to My sharing, then click"Add sharing"
(Note: the receiving sharing device cannot be shared again).
3. Click " " to edit sharing, slide to left to delete
sharing.
Sharing Device
7
Mobile
10:18 95%
*********@****.com
Log Out Setting
Shared Device
Voice Control
Version V1.0.1
Anson
Voice Control
Click the device or group that you want to dim on device list and
group list into Dimming Interface.
Search "Mi-Light Smart" on third-party platform APP and set up.
APP Control
5
Shared Device
Mobile
10:18 95%
My sharing
You share the device to below users
Sent sharing Received sharing
Jack
Miranda
Add sharing
Pierson
Delete
Jack
Click speed+ under dynamic mode.
Click speed- under dynamic mode.
Mobile
10:18 95%
Controller
White Light Timer
Other Miboxer Gateway manuals
