Microsoft Lumia Administrator Guide

Microsoft Lumia –how to insert your SIM card
Firstly, you need to remove the back of the handset from the
body of the phone; holding the Lumia upright, and with the
screen facing away from you, place your thumb in the middle of
the phone's back, just below the camera lens. With your other
hand, hook your finger over a top corner and pull the coloured
back towards you - you should see and hear it unlatch. Repeat
this process on the other top corner, and then the back of the
phone should be free to remove. If the battery has already been
inserted, you'll need to remove it to insert the cards.
The micro-SIM and a microSD memory card (if you are using
one) slide into slots in the edge of the battery compartment.
There are indicators on the information strip to show which
cards go in which slot, and which way round. The microSD goes
in the holder nearest the camera lens (below right), with the
thin end going in first and the gold-coloured contacts facing
down. The nano-SIM card goes in the holder furthest away from
the camera lens (below left), again with the gold-coloured
contacts facing down, and with the cut-off corner end inserted
first.

If you needed a new sim card, you will have received a triple
sim card pack. You’ll need to pop out the appropriate sim
card that is needed for your Lumia
Microsoft Lumia uses a Micro sim card.
With the cards installed, replace the battery (making sure
that the contacts are lined up with the body of the phone)
and then carefully replace the back cover, pressing it into
place all around the edges to ensure the back lines up with
the screen.