Microtech 110180254 User manual

MICROTECH
DIGITAL MICROMETER IP65
USER MANUAL
1μm
IP65
ISO 17025
calibration
HOLD
function
FRICTION
thimble
ISO 9001:2015
ISO17025:2017

MICROTECH SPECIFICATION
Item No Range Resolution Accuracy Dimensions Micrometer
head
Protection
class
C L B D
mm inch mm
μ mmm mm mm mm
110180254 0-25 0-1”
0,001
±2 24 32 7 2
friction
IP65
110180504 25-50 1-2” ±2 33 56 8 2 IP65
110180754 50-75 2-3” ±2 48 85 12 2 IP65
110181004 75-100 3-4” ±3 60 112 12 2 IP65
110181254 100-125 4-5” ±4 73 135 14 2 IP65
110181504 125-150 5-6” ±4 86 160 16 2 IP65
DOUBLE RANGE MICROMETER
110180514 0-50 0-2” 0,001 ±3 33 56 8 2 friction IP65
110181014 50-100 2-4” ±4 60 112 12 2 IP65
SET
Resetting zero
in absolute measurements
HOLD
Hold measured value.
On /Off the measurement
results to external socket
UNIT
Switching between metric
and English measurement
systems
Long press for Swicth off
0/MODE
Switching on. Switching
between absolute and relative
measurements. Resetting zero in
relative measurements.
FUNCTION

MICROTECH
OPERATION
FUNCTION
1.Clean the oil from the measuring surfaces of micrometer by cloth.
2.If necessary, open the battery cover; insert the battery (type CR2032)
according to the polarity of the electrodes. Blinking display information
or absence suggests replacing battery. After battery replacement on the
screen will be ---------- indication. Press SET button for setting 0.000 .
3 Turn on the display by pressing 0/MODE button.
4 Check the setting display to zero. Contact with each other (or with setting
gauge) measuring surfaces of the anvil and the spindle, using the ratchet
and take a measurement.
Rotation the micrometer screw in the direction of convergence measuring
surfaces using the ratchet.
ip located at the end of screws, used only for reverse spindle.
5 For zero setting, press the O/MODE or SET button and hold it to reset to
Zero.
6 After switching on, the display shows the measured value of the metric/
English system of units. Press UNIT button to switch between metric/
English measurement systems.
7 After switching on, the display shows in absolute or relative terms. Press
O/MODE button to switch between absolute and relative measurement
8 During measure, thimble should rotate only by ratchet. Ensure contact of
workpiece with measuring surfaces of the micrometer so tightly to ratchet
cranked 2-3 times. Try to prevent warping measuring surfaces.
9 This micrometer has auto switch off function (10 min non using) ot press
UNIT button during 2 sec. to switch off.
10 After work the measuring surfaces of the micrometer wipe with a cloth
and apply anticorrosive oil.
WARNING !
- Avoid contact with the body electronics unit micrometer emulsions and oils.
- During the measurements, periodically check the zero setting micrometer.
- Do not make the rotation of the micrometer screw in close measuring surfaces using a thimble.
- Avoid shocks or falling, even with a small height.
- Do not disassemble or adjust the micrometer persons who unrelated to the repair.

MICROTECH
Change without prior notice
MICROTECH
innovative measuring instruments
61001, Kharkiv, Ukraine, str. Rustaveli, 39
tel.: [phone]
www.microtech.ua
[email protected]