Microtech 120126131 User manual

MICROTECH
DIGITAL INDICATOR
Calibration ISO 17025:2017 ISO 9001:2015
USER MANUAL
ISO 17025
calibration
1μm
LIMITS

MICROTECH SPECIFICATION
Item No Range Resolution Accuracy Measuring
force
mm inch mm
μ mN
120126131
0-13 0-0,5”
0,01 ±10 1,3-2,0
120128131
0,001
±5 1,3-2,0
120128132 ±3 1,3-2,0
120128133 ±2 1,3-2,0
120126251
0-25,4 0-1”
0,01 ±10 1,3-2,0
120128251 0,001 ±5 1,3-2,0
120128252 ±3 1,3-2,0
120126501 0-50,8 0-2” 0,01 ±20 1,3-2,0
120128502 0,001 ±5 1,3-2,0
TOL button
short press - activating tolerance mode
indication in bottom of screen
Blinking is indicating actual status
TOL ►▌ OK,▐◄,
long press - setting tolerance value
and tolerance mode using (mm/in, set,
0/ON buttons for selecting value). Long
press TOL button for saving
0/ON button
short press - switch on indicator
long press - switch off indicator
Under absolute mode (ABS indication) with a
short press 0/ON button PRESET value will
indicated.
SET button
short press - selecting relative or absolute
(ABS indicating) measuring mode
long press - setting PRESET value with
using (mm/in, set, 0/ON buttons for
selecting value). Long press SET button
for saving PRESET value.
mm/in button
short press - mm/inch conversion
long press - change measurement’s
direction (+/-)
MAX/MIN button
short press - mode select max/min/combination
Will be indicating max or min measured value.
Press 0/ON button to clear value
BUTTON FUNCTIONS

MICROTECH
OPERATION INSTRUCTIONS
Clean the oil from the measuring rod and measuring anvil.
Switch on indicator with using O/ON button (short press)
Use p.2 of this manual (button functions) to select mode or functions.
Attach indicator in the stand
in the working position in relation
to testing object.
Check the zero setting. Provide tightness
of the measuring rod amount 0.4 mm – 0.6 mm
in relation to testing object. Press button O/ON to zero setting.
Check the stability of the zero position of the 4-5x caging.
Wipe the testing object with a clean soft cloth.
WARNING !
Measuring rod should move without shock at the end of turn.
Avoid contact with the indicator and oil emulsion.
Do not turn indicator when it is fixed in the tool holder by a sleeve
BATTERY REPLACEMENT
If necessary, open the battery cover on the bottom
side of the body, insert the battery (type СR2032)
according to the polarity of the electrodes.
Blinking display information or absence suggests to replace battery.

MICROTECH DIMESIONAL DRAWINGS
Change without prior notice
MICROTECH
innovative measuring instruments
61001, Kharkiv, Ukraine, str. Rustaveli, 39
tel.: [phone]
www.microtech.ua
[email protected]