Microtech 120125131 User manual

MICROTECH
DIGITAL INDICATOR IP65
Calibration ISO 17025:2017 ISO 9001:2015
USER MANUAL
ISO 17025
calibration
1μm
IP65
PRESET
HOLD

MICROTECH SPECIFICATION
BUTTON FUNCTIONS
Item No Range Resolution Accuracy Force
mm/inch
Preset
ABS
Proof
USB DATA
mm inch mm inch
μ mN
120125131
0-12,7 0-0,5”
0,01 0.0005” ±10
0.6-1
• • •
IP65
•
120125132
0,001 0.00005”
±6 • • • •
120125133 ±4 • • • •
120125134 ±3 • • • •
120125135 ±2 • • • •
120125250
0-25,4 0-1”
0,01 0.0005” ±20
0.7-1.2
• • • •
120125251 ±10 • • • •
120125252 0,001 0.00005” ±6 • • • •
120125253 ±4 • • • •
120125500
0-50,8 0-2”
0,01 0.0005” ±20
1.2-2.2
• • • •
120125502 0,001 0.00005” ±7 • • • •
120125503 ±5 • • • •
120125900
0-100 0-4”
0,01 0.0005” ±30
3-5
• • • •
120125901 ±20 • • • •
120125902 0,001 0.00005” ±12 • • • •
120125904 ±8 • • • •
HOLD
keep data on display unchanged
ON / OFF
switch power on and off
UNIT
mm/inch selection
0
ZERO setting
SET
PRESET value

MICROTECH
OPERATION INSTRUCTIONS
WARNING !
Measuring rod should move without shock at the end of turn.
Avoid contact with the indicator and oil emulsion.
Do not turn indicator when it is fixed in the tool holder by a sleeve
BATTERY REPLACEMENT
If necessary, remove locking screw and open
the battery cover on the bottom side of the body,
insert the battery (type СR2032)
according to the polarity of the electrodes.
Blinking display information or absence suggests to replace battery.
Clean the oil from the measuring rod and measuring anvil.
Switch on indicator with using ON button (short press)
Use p.2 of this manual (button functions) to select mode or functions.
Attach indicator in the stand in the working position in relation to testing object.
Check the zero setting. Provide tightness
of the measuring rod amount 0.4 mm – 0.6 mm
in relation to testing object. Press button Oto zero setting.
Check the stability of the zero position of the 4-5x caging.
Wipe the testing object with a clean soft cloth.
DATA TRANSFER
Remove locking screws on indicator and connect optional USB cable to connect
digital indicator to PC. (check accesories list on www.microtech.ua).
Inidcator connecting in USB HID mode (keyboard mode) and send data direct to
requested application. Use button on optiona USB data cable to transfer data.

MICROTECH DIMESIONAL DRAWINGS
Change without prior notice
MICROTECH
innovative measuring instruments
61001, Kharkiv, Ukraine, str. Rustaveli, 39
tel.: [phone]
www.microtech.ua
[email protected]