Mid America Motorworks 619-800 User manual

Mamotorworks
@CorvettePassion
MidAmericaMotorworks
CorvettePassion
INSTRUCTION SHEET
Part Number
2900 North Third Street, Effingham, IL 62401
800.500.1500 • Worldwide: 217.540.4200 • FAX: [phone]
www.mamotorworks.com • [e-mail]
©Mid America Motorworks, Inc. All rights reserved.
Application:
Tools Needed
License Plate
UNDER HOOD INSTALLATION
STEP 1.
Mount the receiver in this location using the double-backed tape pad.
STEP 2.
Run the double-strand output wire forward and down through the opening at bottom of radiator shroud. Secure wire
with tie wraps later. Run antenna wire along same path, slightly separated from power wire.
STEP 3.
Place black ground wire terminal over existing grounding stud and secure with nut provided.
UNDER BODY INSTALLATION
STEP 4.
Drive up on ramps or jack up one side. Fore safety, use a jack stand. While holding the motor, carefully pull the plate
base out and into the “show” position. Attach the long bracket to the base using the screws and nuts provided. Screws
point up as shown.
619-800
Part Includes
Powered Front License Plate Frame
Corvette 2006-2013

INSTRUCTION SHEET
Toll Free: 800.500.1500 • Worldwide: 217.540.4200 • www.mamotorworks.com • [e-mail]
000-000
Description (cont.)
Page 2
STEP 5.
Position the base so there is a 1/16” gap in front of the spoiler. Attach the base to the “Z” brackets with screws
pointing up.
STEP 6.
Use the existing body screw to fasten the rear bracket.
STEP 7.
Slip 18” of sheathing over the wire from the receiver
that was previously lowered through the opening behind
the radiator shroud. Drill or slit an opening through the
rubber air dam and pull the sheathed wire through.
STEP 8.
Connect the sire terminals to the motor in three steps:
STEP 9.
Connect the B+ extension tab to the fuse box power stud. The receiver draws negligible current and is directly
connected to the battery lead.
OPERATION
Simply push and hold the remote “up” or “slowed” button for 4-5 seconds to activate the transport system. Only hold
the button down long enough to complete the transport function. Do not hold the button down for more than 30
seconds to avoid possible motor or circuit damage.
All moving components of the transport system are constructed of stainless steel and other durable materials to provide
a reliable and maintenance free life.