Middle Atlantic Products SRS Series User manual

12 Mounting
Holes
Bottom
Pan
Locking
Panel
Squaring
Panel
Part #
SRS Series
instruction #
I-0900
Rev.
I 1-23-04
Instruction # Rev.
I
I-0900
North Corporate Drive
Riverdale, NJ 07457
Voice 973-839-1011
Fax [phone]
Instruction # Date:
I-0900
Rev.
I1/23/04
Part #
SRS Series
Page:
1 of 2
Assembly:
full
www.middleatlantic.com
SRS
Assembly Instructions
1) Position and center SRS in millwork with setback
 desired
2)Using 2 preliminary mounting hole locations attach
 the SRS to the millwork
Preliminary
Mounting
Holes
3) Remove "Locking Panel" and slide rack out
4) Secure SRS using 12 mounting points indicated
  in drawing
(4x)
(4x)
(4x)
5) Attach rackrail to the sliding section using hardware
 provided, finger tighten only
6) Install squaring panel approximately 1/3 of the way
 down from the top of the rackrail using hardware
 provided. Note: The squaring panel remains in place
 until some of the equipment is loaded
7) Final tighten the rackrail to the sliding section
8) Test the sliding carriage operation. Adjust mounting
 positions as necessary should interference with the
 millwork occur
9) Attach the Locking panel
10)Rail Stops serve to maintain a plumb position when rack
 is closed. Mount 2 stops per side in the highest position
 possible while maintaining contact with the backside of
 the rackrail in the closed position. Wood screws are
 for this provided attachment (see illustration above)
Rail Stops
(stack 2 per side)
Note:If optional cable carrier
 is used it must be
 installed prior to rackrail.
 See page 2

Page:2 of 2 Assembly: full
Optional
SRS Cable Carrier Instructions
1) Attach the Hinge Mounting Plate
 to the rear surface of the SRS bottom
 pan with four 10-32 socket head screws
2)Attach the Cable Carrier Hinge to the
 rear of the Hinge Mounting Panel with
 four 10-32 socket head screws
3)Attach front of Cable Carrier to the
 SRS Chassis with four 10-32 socket
 head screws
Note:Carefully examine
 drawing for details
 of which side hinge
 mounting panel goes
 to
Bottom Pan Hinge Mounting Plate
SRS Rear Rails
SRS Series rough-in pan
mounting point locations
3x 18.125
3x 12.125
4x 17.34
18.69
15.95
11.0
8.0
.000
(from trim)
9.55
19.09
FRONT
all dimensions in inches unless otherwise noted
4x 13.97
2.95
4x 1.59
3.95
(only mounting holes shown)