mikroElektronika Click User manual

1. Introduction
Once you have soldered the headers your
board is ready to be placed into desired
mikroBUS™ socket. Make sure to align the
cut in the lower-right part of the board
with the markings on the silkscreen at the
mikroBUS™ socket. If all of the pins are
aligned correctly, push the board all
the way into the socket.
3. Plugging the board in
2 3
2. Soldering the headers
1
4. Essential features
Turn the board upward again. Make sure
to align the headers so that they are
perpendicular to the board, then solder the
pins carefully.
Turn the board upside down so that
bottom side is facing you upwards. Place
shorter parts of the header pins in both
soldering pad locations.
Before using your click board™, make sure
to solder 1x8 male headers to both left
and right side of the board. Two 1x8 male
headers are included with the board in
the package.
click
BOARD
www.mikroe.com
Adapter click Manual
ver. 1.00
0 100000 023860
Adapter Click™is an accessory board in
mikroBUS™form factor. It’s a compact
and easy solution for adding mikroBUS™
to IDC10 adapter to your design. It
features 2x5 connection pads and two
jumpers for SPI/I2C selection. Adapter
Click™communicates with the target board
microcontroller via mikroBUS™ I2C (SDA,
SCL), SPI (MISO, MOSI, SCK, CS), UART
(RX, TX), INT and PWM lines. The board is
designed to use 3.3V and 5V power supply.
Adapter click
There are two ways of establishing such
connection: using male or female IDC10
connectors. Both are provided with the
package. You may solder male IDC10 header
on the top side of Adapter Click™ and connect
the add-on board directly or via IDC10 fl at
cable. In some cases, female header socket is
a better choice. Solder it either on the top, or
the bottom side, depending on which one is
more convenient in given circumstances.

8. Support
MikroElektronika off ers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
.com
5. Adapter Click™ Board Schematic
MIKROBUS DEVICE CONN.
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
VCC3.3
1 2
3 4
5 6
7 8
9 10
CN2
SCK/SCL
MISO/SDA MOSI
CS
RC1RC0
VCC
TX RX
MISO/SDA
SCK/SCL
VCC
VCC5
TX
RX
MOSI
MISO
SCK
SCL
SDA
MISO
SDA
SCK
SCL
RC1
RC0
CS
J2
J3
J1
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specifi cation and information contained in the present schematic are subject to change at any time without notice. Copyright © 2013 MikroElektronika. All rights reserved.
6. Jumpers
There are two jumpers for SPI/I2C selection
and one used to select whether 3.3V or 5V
power supply will be used.