mikroElektronika Smart ADAPT MINI User manual

MikroElektronika
Smart ADAPT MINI™
Manual
All Mikroelektronika’s development systems feature a large number of peripheral
modules expanding microcontroller’s range of application and making the
process of program testing easier. In addition to these modules, it is also
possible to use numerous additional modules linked to the development system
through the I/O port connectors. Some of these additional modules can operate
as stand-alone devices without being connected to the microcontroller.
Additional Board

MikroElektronika
Figure 1: Smart ADAPT MINI additional board
How to connect the board?
The additional board can be easily connected to a development system via a 2x5 connector CN1. This connector is
connected to a development system’s port via a at cable with IDC10 connectors on its ends, Figure 3. Connection with
another additional board or a device is established via a 2x5 connector CN2. The additional board can be supplied with
the power supply voltage from the development system it is connected to.
How to use the board?
In order to send a signal from I2 to O5 pin, it is necessary to place jumper over the appropriate pin on the additional
board, Figure 2. In this way, connection between I2 and O5 pins is established, which is indicated with red lines on the
next Figure. The same applies to all pins. It is necessary to follow designations next to pins supplied on the additional
board and place jumper over the appropriate ones. Several jumpers may be placed on the board at the same time.
Smart ADAPT MINI
The Smart ADAPT MINI additional board is used to redirect signal that is sent from a pin on the development system to
a pin of another additional board or device.
Key features:
- Two output and two input ports.

MikroElektronika
Figure 3: The Smart ADAPT MINI additional board connected to a development system
VCC VCCOUT
CN1
INPUT1 OUTPUT1
CN3
I3 O3
I1 O1
I5 O5
I7 O7
I2 O2
I0 O0
I4 O4
I6 O6
I0
I1
I2
I3
I4
I5
I6
I7
VCC
GND
O7
O6
O5
O4
O3
O2
O1
O0
O7
O6
O5
O4
O3
O2
O1
O0
Figure 2: Redirection of signal

MikroElektronika
78.21mm
36.58mm
Figure 5: Dimensions of the Smart ADAPT MINI additional board
VCC VCCOUT
CN1
INPUT1 OUTPUT1
CN3
I3 O3
I1 O1
I5 O5
I7 O7
I2 O2
I0 O0
I4 O4
I6 O6
I0
I1
I2
I3
I4
I5
I6
I7
VCC
GND
O7
O6
O5
O4
O3
O2
O1
O0
O7
O6
O5
O4
O3
O2
O1
O0
Figure 4: The Smart ADAPT MINI board connection schematic

MikroElektronika

MikroElektronika
If you want to learn more about our products, please visit our website at www.mikroe.com If you are experiencing some problems with any of our products or just need additional information, please place your ticket at www.mikroe.com/en/support If you have any questions, comments or business proposals, do not hesitate to contact us at of[email protected]