Milesight TS101 User manual

3.Power Button Patterns
TS101 sensor equips with power button inside the device for emergency switch on/off. Usually
users can use NFC to complete all steps.
TS101
NFC Area
IK10 Anti-Strike Area
Detection Probe
1.Packing List
1 × TS101 Sensor
2.Hardware Introduction
INSERTION TEMPERATURE SENSOR
FEATURING LoRaWAN
®
1 × Warranty Card1 × Quick Start Guide
Power On
Reset to Factory
Default
Off →On
On →Off
Quickly Blinks
Light On: Device
Is On
Light Off: Device
Is Off
Function Action LED
Press and hold the button
for more than 10 seconds.
Check On/Off
Status
Quickly press the power
button.
Press and hold the button
for more than 3 seconds.
Power Off Press and hold the button
for more than 3 seconds.
4. Configuration Guide
1. Download “Milesight ToolBox” App on an NFC- supported smartphone.
iOSAndroid

IK10 Anti-Strike Area
Insert the probe into the measured object directly; if the density of the measured objected is too
large to insert the probe directly (such as haystack), please use rubber hammer to strike the
anti-strike area of TS101 until the probe is completely inserted into the measure object.
5.Installation
NFC
Besides, it can be configured by dedicated NFC reader provided by Milesight IoT.
2. Open “Milesight ToolBox” App and attach the smartphone with NFC area to read/write the
device until App shows a successful prompt. (Default config password: 123456)
6. FCC Statement
Any changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. This device complies with part 15 of
the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits aredesigned to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator& your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement:
All Software & files can be downloaded from
https://www.milesight-iot.com/documents-download/
Cloud App Quick Start Guide
Milesight IoT Co., Ltd. www.milesight-iot.com
Add:Building C09, Software Park Phase III,
Xiamen 361024,Fujian,China