MIMAKI TS500 User manual

Make sure to wear the attached
goggles and glove when you work.
© 2013 MIMAKI ENGINEERING CO., LTD. M014553-01(D202546-11)-28082013
TS500/Tx500 Daily Care
With a view to using this machine in a better condition, please be sure to the following daily care after at the end of the
daily work. Please refer to “Daily care manual” for the detail.
Cleaning of around the heads
1. Perform [HEAD MAINT.], move the carriage to the
maintenance position and open the left maintenance cover.
(1) Press the key in LOCAL.
(2) Press the key.
(3) Press to select [HEAD MAINT.].
(4) Press the key.
(5) Open the left maintenance cover.
2. Soak the clean stick or the waste cloth in the maintenance cleaning liquid and wipe off an
accumulated ink on the side of the head and on the bottom surface of the slider.
3. Soak the COTTON CIEGAL®in the maintenance cleaning liquid and wipe off the mark of
the cap rubber attached on the nozzle surface from the rear side to the front side.
4. Close the left maintenance cover.
5. Press , complete the cleaning.
Left maintenance
cover
MAINT.
ฌЭ
Side surface of the head (shown in deep gray)
Nozzle part Bottom surface of the slider (shown in gray)
[Before cleaning] [After cleaning]
• Do not touch the nozzle surface, because the cleaning will be performed in the procedure
No.3.
[Before cleaning] [After cleaning]
COTTON CIEGAL®
Mark of the cap
• Immerse much enough so that maintenance liquid may drip from it.
• Do not wipe the nozzle surface with dry COTTON CIEGAL®.
• If COTTON CIEGAL®has fluffed, replace it.
• If ink solid adheres to COTTON CIEGAL®, change the surface to use for cleaning or
replace it.
IT

Cleaning of the station
1. Perform [STATION MAINT.], move the carriage to the
maintenance position and open the left maintenance cover.
(1) Press the key in LOCAL.
(2) Press the key.
(3) Press to select [STATION MAINT.].
(4) Press the key.
(5) Open the left maintenance cover.
Cleaning of the cap
Wipe off the ink of the cap rubber and cap cover with clean stick or waste cloth dipped in cleaning solution for
maintenance.
Cleaning of the wiper
Wipe off the ink of the wiper and bracket with clean stick or waste cloth dipped in cleaning solution for
maintenance.
Cleaning of the wiper blade
Wipe off the ink of the wiper blade with clean stick or waste cloth dipped in cleaning solution for maintenance.
2. Close the right maintenance cover.
3. Press , complete the cleaning.
Right maintenance
cover
MAINT.
[Before cleaning] [After cleaning]
Cap rubber
• After cleaning, make sure
that the cap rubber and mesh
in the cap are not removed.
Cap cover
Bracket
Wiper
[Before cleaning] [After cleaning]
• After cleaning, make sure the edge of the wiper is horizontal.
[Before cleaning] [After cleaning]
Wiper blade
Wiper blade