MIMAKI JV33-160A Operating manual

www.inktec.com
Mimaki
JV33-160APrinter
InkTec SubliNova Ink User
Monthly Maintenance Guide

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
02
Step 1. : Move the Head Carriage
Please follow the instruction below to move the head carriage.
Step 2. : Cleaning the edge of a head
After the head carriage is moved to the left,
Coat the cotton bud or cleaing stick with SWAto clean
the plate around head.
* If the heads are not cleaned regularly the
condition will deteriorate.
Step 3. : NOZZLE WASH
6
①
1
①
3
①
4
①
5
①
2
①

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
03
At ④step, coat the tissue paper with SWAand clean the front
and back of the wiper.
* If the wipers are not cleaned regularly the nozzles can't be
recovered even after cleaning.
At ⑤step, Drop SWA down into the CAP (ⓐ) and wipe it (ⓑ) to clean the CAP (ⓒ).
* If the CAP is not cleaned regularly, the drainage line can become clogged
After finishing the CAP clean, pour SWA into top of the
CAP until full.
At ⑥step, set the wash time for ten minutes,
and click enter to perform the nozzle wash.
a
①
b
①
c
①

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
04
Step 4. Cleaning the Head Nozzle
Coat the superfine fibre cloth (lint free) to clean the nozzles.
Wipe every nozzles up and down for ten minutes.
* Note : Do not wipe too hard because it can damage
The Nozzles
Step 5. Checking the nozzle
Push enter key to return the head carriage where it was.
Perform cleaning cycle and check the nozzles.