CLSD Series LED Drivers
LED Dimmable Drivers CLSD Series
Programming Instructions
Step 1:
Verify you have the following materials:
Your PC for programming•
Programming Cable (USB)•
CLSD Programming Box•
CLSD Series LED Driver to be programmed•
㻸㻶㻥
㻳㼕㼒㼊㼕㼄㼐㼐㼌㼑㼊㻃㻥㻲㻻
㻳㼌㼑㻃㼉㼒㼕㻃㼓㼕㼒㼊㼕㼄㼐㻃㼕㼈㼚㼕㼌㼗㼌㼑㼊
㻸㻶㻥㻃㻦㼄㼅㼏㼈
㻰㼌㼑㼌㻐㻸㻶㻥
㻳㻦
Step 2:
Verify you have completed the installation process. If not, please
download the one-time NMB Technologies Programming Utility
installer at: http://www.nmbtc.com/lighting/install
Step 3:
Plug the USB Connector end of the Programming Cable into your PC.
Step 4:
Plug the Mini-USB Connector end of the Programming Cable into the
CLSD Programming Box.
Step 5:
Remove the dust and moisture barrier tape from the side of the Driver.
Set this aside for re-application when the driver programming has been
completed.
Step 6:
Run the NMB Lighting LED Driver Utility from the Start Menu. The Utility
will prompt your next step: “Waiting for Programming Box.”
Step 7:
Connect your Programming Box to the CLSD Driver by aligning and placing
the box on the pins. Place and hold the Programming Box to the CLSD driver.
Programming box Model CLSD004 requires you to maintain contact between
the box and the driver while programming. The CLSD005 Programming Box
model inlcudes clips for easier mounting.
