Minelab Explorer SE User manual

Field Guide
The exact location of a target can
be located by using p i n p o i n t.
1 Once the approximate target location is
known, move the coil away from that area and
press p i n p o i n t.
2 Sweep the coil slowly over the target location.
3 Taking note of the response, reduce the span
of each successive pass of the coil until you are
confident of the location of the target. Make a
mental note of the position or, mark a line on
the soil with your shoe or a digging tool.
4 Move to one side so that you can pass the coil
over the target at right angles to your initial
direction. When the detector sounds you
should know exactly where to dig.

Increases Sensitivity
Switches between Semi-Automatic
and Manual Sensitivity
Decreases Sensitivity
Turns the detector On/Off
Reduces electrical interference
or Noise
Accesses the Menu to change
other functions
Turns Iron Mask On / Off,
switching between three screens:
Increases Threshold Volume
Switches between Normal
and Full Screen Display
Decreases Threshold Volume
Turns on the Backlight
Switches between Smartfind
and Digital Detect Displays
Iron Mask ON -
adjustment screen
Iron Mask ON -
Smartfind or Digital
Smartfind or Digital
(Iron Mask OFF)
Retraces your steps back
through the displays
Pinpoints the exact location
of a target 4903-0035_1.0