Miniature Scenery Elven Sanctuary of Souls User manual

Preparation
Once you clear some table space you will need a
hobby knife and glue (PVA, wood glue, hobby glue)
and a file or small piece of sandpaper to be used for
cleaning up any tiny imperfections.
It’s a good idea to familiarise yourself with how the
pieces fit together before gluing.
Getting Started
I. Parts should remove easily from the board by
pressing through and popping them out. It’s a
good idea to cut through the tiny joins first
though, and some parts (particularly smaller,
more detailed parts) may need more careful
persuasion.
II. Use a file or sand paper last to completely
remove the tabs that might remain.
III. Parts may be a very tight fit, slight trimming
or sanding of parts may be needed for ease of
assembly.
Construction
Slot the parts together as shown by the pic-
tures below, applying glue wherever there is
a connection.
Allow the model to completely dry before
painting it. This is a complex kit with many
small parts. Allowing each section to dry
thoroughly before heading to the next is
strongly recommended.
INSTRUCTIONS
Elven Sanctuary of
Souls
Some parts of this kit are very fine, or
have engraving very close to edges.
Make sure you cut through any tabs
carefully with a hobby knife first to
avoid damage.
The exclusive copyright on the model designs are the property of CNC Workshop Ltd. © Copyright CNC Workshop Ltd., 2006. All rights reserved. Made in Australia

Use a Straight edge or square to
make sure these parts are as ver-
tical as possible.
(it will make for a better model
later on. Trust me).

These parts can be sanded and
filed to shape for a more gem-like
appearance.
It’s also not important where you
put them. I’ve been fairly random
on the test model.

Once again, these parts way cooler if
you sand them to shape a bit.
Just sayin’.

The central hole can be used with
a toothpick to help align the
assembly.

Sanding to shape.
You know the drill.

CAREFUL.
Quite weak here.

This part is supplied with the parts
lightly joined so that if the follow-
ing step is a bit scary, you can just
glue some paper on the back to re-
inforce it and leave well alone.
It will, of course, look WAY niftier
if you remove the pieces and re-
glue them at an
angle and sand/file
the edges (happy
green colour) as
shown.

The Happy green bits
mentioned earlier.
Again with the sanding.
Really, it WILL make your
model look much better.

Alternate Gun.
(can be left swappable with
the other weapon. It’s a bit
of a wiggle, but it does go
in without glue).