Miniature Scenery Ursula Heavy Mortar User manual

Preparation
Once you clear some table space you will need a
hobby knife and glue (PVA, wood glue, hobby glue)
and a file or small piece of sandpaper to be used for
cleaning up any tiny imperfections.
It’s a good idea to familiarise yourself with how the
pieces fit together before gluing.
Getting Started
I. Parts should remove easily from the board by
pressing through and popping them out. It’s a
good idea to cut through the tiny joins first
though, and some parts (particularly smaller,
more detailed parts) may need more careful
persuasion.
II. Use a file or sand paper last to completely
remove the tabs that might remain.
III. Parts may be a very tight fit, slight trimming
or sanding of parts may be needed for ease of
assembly.
Construction
Slot the parts together as shown by the pic-
tures below, applying glue wherever there is
a connection.
Allow the model to completely dry before
painting it. This may be a complex kit with
many small parts. Allowing each section to
dry thoroughly before heading to the next is
strongly recommended.
INSTRUCTIONS
URSULA
SEIGE
MOTAR
The exclusive copyright on the model designs are the property of CNC Workshop Ltd. © Copyright CNC Workshop Ltd., 2006. All rights reserved. Made in Australia
Some parts of this kit are very
fine, or have engraving very
close to edges. Make sure you
cut through any tabs carefully
with a hobby knife first to avoid
damage.

Assemble All legs from
three parts provided.
(they will be next to
each other on the
parts sheet).
1
2
3 5
6
7
8
4

Note Carefully the
differences between
parts!!!
R
L

Insert tab into slot at back
and tilt forward.

Cut Supplied 5mm
dowel to approx
28mm lengths.

The Gun may be a very
tight fit. Enthusiastic
wiggling may be required.

Use 2mm diameter tubing/
rod/ or toothpicks for
Barrel, cut to approxi-
mately 14mm long.

Alternate parts. With or
Without Guns.