MinimumRC P-51 Mustang User manual

P-51 Mustang
Assembly Instruction
All manuals and user guides at all-guides.com
all-guides.com

1. Assemble the base.
2. Cut off the rudder parts.
All manuals and user guides at all-guides.com

3. Connect the rudder to the fuselage with paint sticker. Note that the
distance between the rudder surface and the fuselage plate is 1mm.
All manuals and user guides at all-guides.com

4.Installing the servo base（plywood）.
5. Paste fuselage coated stickers and assemble fuselage panels.
All manuals and user guides at all-guides.com

6. Installation of wing support; Install aileron servo and cover it with
sticker.
All manuals and user guides at all-guides.com

7. Coating paper coated motor.
8. After the motor wire passes through the hole in the middle of the
fuselage, the bottom of the fuselage is filled.
All manuals and user guides at all-guides.com
all-guides.com

9. Cut off the elevator and connect with the hinge patch.
(the patch is better fixed with glue).
Note that there is a 1 mm gap between the rudder and the tail plate.
All manuals and user guides at all-guides.com

10. Install the horizontal tail, the elevator needs to move freely.
11. Cut off the aileron and connect with the hinge patch.
(the patch is better fixed with glue).
Note that there is a 1 mm gap between the aileron and the wing.
All manuals and user guides at all-guides.com

12. Transparent tape can improve the torsional rigidity of aileron.
All manuals and user guides at all-guides.com

13. Bend the wing along the notch.
14. Installation of the wing.
All manuals and user guides at all-guides.com

15. Reinforce the wing with φ1mm carbon rods.
16. Installation of the control horns.
All manuals and user guides at all-guides.com
all-guides.com

18.
All manuals and user guides at all-guides.com

19. Installation of the servos.
All manuals and user guides at all-guides.com

20. Connect the pushrod clips & pushrods with heat shrinkable tube
and fix them with glue.
21. Installation of the pushrods.
All manuals and user guides at all-guides.com

22. Connect the pushrod clips & pushrods with heat shrinkable tube
and fix them with glue.
23. Installation of the pushrods.
All manuals and user guides at all-guides.com

24. Attach the receiver to the fuselage with Velcro.
All manuals and user guides at all-guides.com
all-guides.com

25. Attach the battery to the fuselage with Velcro.
Completion of assembly
First test flight
·The center of gravity is 10 mm from the leading edge of the wing. Move
the battery forward and backward to adjust the center of gravity.
·The amount of elevator, rudder and aileron is 5 mm for each side. Please
adjust the rudder surface to the level before flight test.
Explore the ultimate possibility of airplane kits
MinimumRC.COM
All manuals and user guides at all-guides.com