MinimumRC Piper Cub J-3 User manual

MinimumRC
Piper Cub J-3
Assembly Instructions
1. Use a Hobby Knife to remove parts from the board
2. Do not remove unused parts in advance to prevent loss!

2.
3.
4.

5. Screw in the screw to secure the landing gear
6. Press the crease along the dotted line and bond the cabin reinforcement

7. The finished cabin reinforcement is shown in the figure.

8. Combined body side panel
9.
10.

11.
12.

13. Combined fuselage floor.
14.

15.
16.

17.
18.

19.
20.

21.
22.

23.
24.

25.
26.

27. The hood is attached to the body by snaps and is glued without glue.
28. Overall sanding and shaping.

29. Cut off the hood back support piece
30.

31. Use Du-Bro DUB916 Electric Flyer Hinge Tape for the Rudder and Elevator hinges.
32.

33.
34. Symmetrical assembly of wings on both sides

35.
36.

37.
38. Use a heat shrinkable sleeve on the wire to act as a block

39. Attach windshield and side windows with RC Canopy Glue.
40.