Minuteman 957724 PRIME User manual

1
957724PRIMECharger
INSTALLATION
MODEL:E17/E20
DOCUMENTEDBY:JonathanSanchez
DATE:06/20/18
P/N999081

2
CHARGERINSTALLATION
Using the (3x) included #10‐24x3/4” flat
head machine screws (p/n: 712544), attach
the Charger Adapter Plate (p/n: 172089) to
the upper electrical box, as shown.
Angle the charger unit (p/n: 957724) as
shown to insert inside electrical control
box. Mount using (2x) #8‐32x3/8” pan
head machine screws (p/n: 711133) on
the top tab‐mounts.
Install lower (2x) #8‐32x3/8” pan head
machine screws (p/n: 711133) by using a
long magnetic philipps‐head driver and
angling the screw driver as shown.
P/N999081

3
CHARGERWIRING
123
456
Remove indicator light cap (fig. 2) and insert plastic lock nut through
indicator light assembly (fig. 3). Insert light end of assembly through
the opening on the machine’s back panel (fig. 4) and insert cover
over light housing (fig. 5). Re‐install indicator light cap and secure
onto back panel by tightening the retaining ring on the rear of the
panel (fig. 6). NOTE: This can be done before or after the indicator light is
attached to the charger.
Attach indicator light wiring into the port as shown (fig. 7 & 8) and secure
connector onto the charger. Connect green connector onto green terminal
on the charger (fig. 9). Attach power cord and tighten screw to secure
power cord (fig. 10 & 11).
789
10 11
P/N999081

4
WIRING
Attach common wire, from battery, into Lockout 2.
Attach harness wire, from harness, into Lockout 1.
Attach indicator light onto back‐panel if this has not been attached yet.
See page 3 for exact details.
P/N999081

5
DCOUTPUTWIRING
Remove cap screw and attach black wire onto (A) and red wire onto (B) as shown.
P/N999081