ML Accessories Knightsbridge SK005A Instruction Manual

11
230V
50Hz
IP
54
INSTALLATION & MAINTENANCE MANUAL
SK005A

• Installation of this product should only be carried out by a qualified electrician or competent person
to the latest Building and current IEE Wiring Regulations (BS7671)
• Please isolate mains prior to installation/maintenance
• Check the total load on the circuit (including when this product is fitted) does not exceed the rating
of the circuit cable, fuse or circuit breaker
• This product is Class I and requires an earth
• This product is IP54 rated (only when the product is in the closed position with no appliances
attached)
• Provide power to the required point of installation
• Locate a suitable place to mount the product. We recommend a surface thickness of min 10mm to
max 50mm
• Cut a 90mm hole in the surface allowing a 25mm clearance around the hole (see Fig 1)
• Note: ensure there is sufficient space beneath the surface when the product is in the closed
position
These instructions should be read carefully and retained after installation by the end user for
future reference and maintenance.
These instructions should be used to aid installation of the following product:
SK005A
INSTALLATION
SAFETY
CONTENTS
90mm
25mm
Fig 1

• Remove the mounting collar and rubber gasket by rotating anti-clockwise
• Insert the product through the hole
• Put product in desired orientation and insert rubber gasket to bottom. Tighten the mounting collar
to the underside of the surface (see Fig 2)
• Connect to mains supply via the pre-wired cable and plug
• To raise the product, gently lift the handle on the top cover. Raise until it clicks, this means it’s
locked in position (see Fig 3a)
• To lower the product press the release button (see Fig 3b)
OPERATION
Surface
Rotate
clockwise
Fig 2
Fig 3a Fig 3b
Lift the handle and
pull product up

• Always use the handle to raise/lower the product (see Fig 4)
• When the fitting is switched on, the Bluetooth signal indicator will start flashing - at this point the
fitting is discoverable (see Fig 5)
• Turn on the Bluetooth on your device and search for devices
• Locate the fitting on the Bluetooth device list (called SPEAKER) and pair
• Once the device has paired successfully an audible beep will be heard and the Bluetooth signal
indicator will flash
Fig 4
SETTING UP BLUETOOTH SPEAKER
Fig 5

This product must be disconnected from the circuit if subjected to any high voltage or
insulation resistance testing. Irreparable damage will occur if this instruction is not
followed.
The fitting should be recycled in the correct manner when it reaches the end of its life.
Check local authorities for where facilities exist.
Clean with a soft dry cloth only, do not use aggressive cleaning products or solvents which
may damage the fitting.
This product has a warranty of 1 year from date of purchase. Failure to install this product
in accordance with the current edition of the IEE Wiring Regulations, improper use, or
removal of the batch codes will invalidate the warranty. If this product should fail within
its warranty period it should be returned to the place of purchase for a free of charge
replacement. ML Accessories does not accept responsibility for any installation costs
associated with the replacement product. Your statutory rights are not affected. ML
Accessories reserve the right to alter product specification without prior notice.
WARNING
GENERAL
WARRANTY
SBSEP17_V2
ML Accessories Group Limited
LU5 5TA
www.mlaccessories.co.uk