ML Accessories OWALL1 Series Instruction Manual

INSTALLATION & MAINTENANCE MANUAL
These instructions should be read carefully and retained after installation by the end user for future reference
and maintenance.
These instructions should be used to aid installation of the following products:
OWALL1xx / OWALL2xx
SAFETY
•This product must be installed in accordance with the latest edition of the IEE Wiring Regulations
(BS7671) and current Building Regulations. If in any doubt, consult a qualified electrician
•Please isolate mains prior to installation or maintenance
•Check the total load on the circuit (including when this luminaire is fitted) does not exceed the rating of
the circuit cable, fuse or circuit breaker
•Please note the IP (Ingress Protection) rating of this product when deciding the location for installation
•This product is Class I and must be earthed
•This product is IP54 rated
INSTALLATION
Note - If this luminaire is being used in conjunction with an external PIR or sensor, please confirm with the
manufacturer of the sensors that they are compatible with the lamps being used
•Provide power to the required point of installation. Suitable IP rated junction boxes should be used
where required
•Round cable should be used for the mains supply. The use of flat cable will cause water ingress to the
fitting
•Remove the baseplate from the luminaire by loosening the screws on either side of the base
•Using the baseplate as a template, mark the location for, and drill the fixing holes ensuring not to
infringe with any gas/water pipes or electrical cables
•Feed the mains cable through the rubber grommet to retain IP rating
•Fix the baseplate using the screws and wall plugs provided (see Fig. 1)
Fig. 1
•Connect the luminaire to the mains supply ensuring the correct polarity is observed: L - Live (brown),
•E - Earth (green/yellow), N - Neutral (blue)
•Align the luminaire with the baseplate and refasten the screws
•Insert suitable GU10 lamp/s
•Switch on and check for correct operation
GENERAL