Mobile Devices C4D-4G4EUWBT V6+ User manual

C4D-4G4EUWBT_V6+ - INSTALLATION GUIDE
V 1.4
20/12/2017

Table of contents
Preface.........................................................................................................................3
Warnings and notices................................................................................................... 3
RF Exposure Information (SAR).......................................................................................3
1. Hardware features.................................................................................................... 4
2. Hardware description................................................................................................5
2.1. External view...................................................................................................... 5
2.2. Internal view...............................................................................................................5
2.3 OBD connector pin out...............................................................................................6
* Please read warnings section at the beginning of the installation guide............................6
2.4 OBD adapter wires......................................................................................................6
3. Preparing/installing the device..........................................................................................7
3.1. Open the device.........................................................................................................7
3.2. Insert/remove the SIM card........................................................................................8
Once inserted the SIM card looks like this:.......................................................................8
3.3. Properly close the device..........................................................................................9
3.3. Install the OBD Dongle............................................................................................11
4. LED sequences.................................................................................................................11
5. Support............................................................................................................................11

Preface
The information contained in this installation guide is subject to changes in order to improve the reliability,
design or features without prior notice. Mobile Devices Ingénierie reserves the right to make changes in the
content without obligation to notify any person or organisation of such changes or improvements. Mobile
Devices Ingénierie can in no event be held liable for technical or editorial errors or omissions herein, nor for
incidental, special or consequential damages from the furnishing, performance or use of this installation
guide.
Please contact our technical support for current updates and supplemental information concerning the use
and operation of this or other Mobile Devices Ingénierie products.
Warnings and notices
The exclamation point within an equilateral triangle is intended to alert the user to the
presence of important operating and maintenance (servicing) instructions in the literature
accompanying the product.
Please read the installation guidelines, as well as the safety and operating instructions before operating your
device. Follow all instructions and heed all warnings in the installation guide.
There is a risk of explosion if the battery is replaced by a wrong battery type. Please discard empty battery
according to local regulations.
Hereby, Mobile Devices Ingénierie declares that the radio equipment type C4D-4G4EUWBT_V6+ is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the
following internet address: http://www.mobile-devices.com/
The device could be used with a separation distance of 0.5cm to the human body. Users have to adopt a
holster/sleeve/cover without any metal components to maintain this distance.
Dispose of used batteries according to the instructions.
RF Exposure Information (SAR)
For this device, the highest reported SAR value for usage near the body is 1.670 W/kg.
According to REDCA Technical Guidance on the publication with a restriction in the Official Journal of
Europe of the reference of standard EN 50566:2017, ensuring the safe a separation distance of 5mm or
less is applied for handled device and body-mounted wireless communication device used by the general
public, the 5mm distance is used for SAR testing and this device is compliance with Specific Absorption Rate
(SAR) for general population/ uncontrolled exposure (Localized 10-gram SAR for head and trunk, limit :
2.0W/kg) specified in Council Recommendation 1999/519/EC, and ICNIRP Guidelines, and RED (Directive
2014/53/EU), and had been tested in accordance with the measurement methods and procedures specified
in EN50566:2017, EN62311:2008 and EN62209-2:2010

1. Hardware features
OBD Dongle
Performance
Processor
Cortex A5
-
500MHz
RAM
128 Mbytes
NAND Flash
256
Mbytes
Power supply
External power supply range
8
-
1
8
V
External voltage
measurement
●
Li
-
pol battery
27
0mA.h
Communication
Modem
4G Cat.4 Europe module (
LE910
-
EU V2
)
Modem antenna
Internal
WLAN
Wifi
WiFi 802.11 b/g/n 2.4G
Bluetooth
BT 4.1 LE
Positioning
GNSS receiver
U
-
blox M8 (
GPS, GLONASS
)
GNSS antenna
Internal
Interface & Telematics features
USB (2.0 Host)
powered (
100mA on 5V minimum
) optional
3D Accelerometer
±2g, ±4g, ±6g, ±8g, ±16g
3 axis Gyroscope
Optional, please contact us
OBD protocols
CAN, KWP2000, VPW, PWM
Additional CAN interface
Optional, please contact us
Environmental
Connectors
OBD connector
Mini USB
Operating temperature
-
2
0
°C
/+55
°C
with Battery
-20°C/+60°C without battery
Dimensions
With OBD con
nector: 27x6
9
,5x
51
mm
Without OBD connector: 27x56.5x51 mm
SIM card
slot
Below value is the real value tested on conductive power, we kept sample at Lab. for trace.
Mobile (UE)
–
GSM
Band Power Class
Power
(dBm)
E
-
GSM 900
4
32.70
DC
S 1800
1
28.67
Mobile (UE)
-
UMTS
Band I
3
22.14
Band VIII
3
23.1
Mobile (UE)
-
LTE
FDD 1: Japan, Korea, Europe
21.85
FDD 3: Europe, Asia, Taiwan
22.28
FDD 7: Europe, Taiwan
22.7
FDD 8: Europe, Taiwan
22.67
FDD 20: Europe
22.69
WLAN
Bluetooth
9.5
WIFI 802.11b
WIFI 802.11g
WIFI 802.11n HT20
14.5
13
13.2

2. Hardware description
2.1. External view
2.2. Internal view
1 : OBD connector
2 : USB connector
3 : Status led
4 : GNSS antenna
5 : SIM holder
6 : Internal battery*
1
2
2
3
4
5
6
* Please read warnings section at the beginning of the installation guide

2.3 OBD connector pin out
Pin #
Comment
2
J1850+ (PWM/VPW)
4
Chassis ground
5
Signal
ground
6
CAN High
7
K line
10
J1850
-
(PWM)
14
CAN low
15
L line
16
Battery voltage
* Please read warnings section at the beginning of the installation guide
2.4 OBD adapter wires
This adapter is only used to connect the OBD to a computer (laptop/desktop).
Pin #
Wire color
2
Yellow
4
Black
5
Grey
6
Green
7
Blue
10
Violet
14
Orange
15
White
16
Red

3. Preparing/installing the device
3.1. Open the device

3.2. Insert/remove the SIM card
The SIM card slot is located between the two electronic cards.
Once inserted the SIM card looks like this:
Insert the card with contact on bottom into
the slot and push it as far as it will go.

3.3. Properly close the device
First, check that the electronic card is correctly inserted in the plastic part and that usb port is
correctly positioned into the casing.
If it’s not inserted proceed as shown below.
GOOD
NOT GOOD
GOOD
NOT GOOD

Second, insert the back cover beginning with the bottom.
Third, insert the top cover beginning with the back and push on top to clip-on the top cover
Finally, place the screw.

3.3. Install the OBD Dongle
Connect the OBD Dongle on your vehicle OBD connector.
4. LED sequences
The Dongle has a two-coloured LED, green and red.
When both colours are brightened, you can see an orange light.
Green LED
Red LED
Sequence
Meaning
Sequence
Meaning
Dongle OFF
OFF
No
Modem
/No GNSS
3 times (50ms ON/100ms
OFF)
3550ms OFF
Ext. Power/Run ON
No
Modem
/Fix GNSS
2 times (50ms ON/100ms OFF)
3700ms OFF
Modem
OK
/No GNSS
1 time (50ms ON/100ms OFF)
3850ms OFF
Modem
OK
/Fix GNSS
2000ms ON
2000ms OFF
Shutdown/Hibernate
30ms ON / 1 s OFF
Idle/Sleep
30ms
ON / 1 s OFF
5. Support
For all questions not related in this installation guide, please contact the support team by email at
[email protected]