Mocka Maya Ladder User manual

WARNING – This is not a ladder. Please do not climb or
step on this product.
Phillips screwdriver required
WARNING: Any furniture that is not anchored to a wall has the
potential to tip over in certain circumstances, i.e. if a child attempts to
climb up on the furniture or in the event of an earthquake. Accordingly,
we recommend that all furniture is anchored to a wall. We supply a
free safety wall anchor with all furniture sold and we recommend
these are used to prevent your product tipping. The fixing device
provided should fit most wall types, but please note that different wall
materials may require different fixing devices from those supplied.
x2
washer
Z
Wall
Screw
r/washer
screw
x1
Y
wall
anchor
x1
X
Safety
Strap
V W
Wall Strap
Hardware Supplied
A
x2
dowel
x18
B
long
screw
Maya Ladder
1
mocka.co.nz | mocka.com.au
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
C
cam nut
x18
x1 x1

1
Maya Ladder
2
mocka.co.nz | mocka.com.au
Assembly Instructions
2
3
A
A
B
B
x16
x2
A
4
5
7
6
1
2
W
V
r/washer
screw
V
ZZ
Ensure all screws and bolts are securely tightened before and during
use . Attach safety strap (V) to the top of the back side of the ladder
using 1x washer (Z) and 1x screw (Y). Tighten with a screwdriver .
Once assembled lift furniture into place into palce,do not drag.
C
C
A
A
A
AA
AA
A
A
A
A
A
A
A
A
A
A
C
C
CC
C
C
C
C
C
Insert 18x cam nuts (C) into panels [3] , [4] , [5] , [6] and [7]. Attach the top
brace [3] in place between the two side legs of the ladder using 2x dowels
(B) and 2x screws (A).Attach each of the shelves in place ,ascending from
the largest to the smallest using 4x screws (A) from outside the legs. Tighten
with a screwdriver.
C
C

34
Move the ladder into the desired location up against a wall. Use a drill to
create a small hole lining up with the top of the safety strap (V). Fasten
to wall using wall anchor (X), washer (Z) and a wall screw (Y). Ensure
unit is balanced and steady before use. You’re done, enjoy!
Wall Strap
x1
wall
anchor
wall
screw
Washer
Strap
X
Z
V
Maya Ladder
Assembly Instructions
3
mocka.co.nz | mocka.com.au
Y