Modus Furniture JAXON CORNER DESK User manual

A. LEFT TOP SECTION 1PC
1ALLEN BOLT
(M8x70) 06
PCS
TOOL REQUIRED
PHILLIPS HEAD SCREW
DRIVER NOT PROVIDED
207
PCS
B. RIGHT TOP SECTION 1PC
D. RIGHT LEG 1PC
3
ALLEN BOLT
(M8x40) 513
PCS
604
PC
FLAT WASHER
(M9)
C. LEFT LEG 1PC
413
PCS
SPRING WASHER
(M9)
JAXON CORNER DESK
ASSEMBLY INSTRUCTIONS
JAXON CORNER DESK ASSEMBLED
E. MIDDLE SUPPORT 1PC F. STRETCHER 1PC
ALLEN BOLT
(M6x90) 04
PCS
SPRING WASHER
(M6) FLAT WASHER (M6)
704 PCS 8ALLEN KEY 01 PC

ATTACH THE STRETCHER (F) TO THE TOP SECTION ASSEMBLY USING FOUR M6X90 ALLEN
BOLTS (3), M6 SPRING WASHERS (6) AND M6 FLAT WASHERS (7). TIGHTEN ALL BOLTS
COMPLETELY WITH PROVIDED ALLEN KEY.
OPTIONAL STEP: THE DESK DRAWER CAN BE POSITIONED ON EITHER THE LEFT OR RIGHT
SIDE OF THE DESK. TO MOVE FROM CURRENT POSITION, REMOVE ALL FOUR BOLT
ASSEMBLIES AND REPOSITION DRAWER OVER CORRESPONDING HOLES. REATTACH AND
TIGHTEN BOLTS.
ON A FLAT, LEVEL AREA LAY DOWN A CLEAN BLANKET OR TOWEL. PLACE BOTH THE LEFT (A)
AND RIGHT TOP SECTIONS (B) UPSIDE DOWN ON. CONNECT THE SECTIONS WITH TWO M8X70
ALLEN BOLTS (1), M9 SPRING WASHERS (4) AND M9 FLAT WASHERS (5) THROUGH THE FRAME.
ADDITIONALLY, USE THREE M8X40 ALLEN BOLTS (2), M9 SPRING WASHERS AND M9 FLAT
WASHERS TO CONNECT THE CORNER FRAMING, PER THE ILLUSTRATION. TIGHTEN ALL BOLTS
COMPLETELY WITH THE PROVIDED ALLEN KEY (8).
A
B
8
1
4
5
8
2
4
5
8
2
4
5
8
3
6
7
OPTION 1 OPTION 2
F

CONNECT THE LEFT (C) AND RIGHT LEGS (D) TO THE TOP ASSEMBLY WITH ONE M8X70 ALLEN BOLT,
M9 SPRING WASHER AND M9 FLAT WASHER THROUGH THE CENTER TOP OF THE LEG. USE TWO
M8X40 ALLEN BOLTS, M9 SPRING WASHERS AND M9 FLAT WASHERS TO CONNECT THE OUTSIDE
EDGES OF THE LEGS. IN TOTAL, SIX BOLT ASSEMBLIES WILL BE USED. TIGHTEN ALL BOLTS
COMPLETELY WITH PROVIDED ALLEN KEY.
ATTACH THE MIDDLE SUPPORT (3) TO THE TABLE TOP WITH TWO M8X70 ALLEN BOLTS, M9
SPRING WASHERS AND M9 FLAT WASHERS. TIGHTEN COMPLETELY WITH PROVIDED ALLEN KEY.
8
4
5
1
8
4
5
2
8
2
4
5
C
D
8
1
4
5
E

WITH THE HELP OF A SECOND PERSON, FLIP THE DESK RIGHTSIDE UP. TO INSTALL THE
DRAWER HANDLE, OPEN THE DESK DRAWER AND UNATTACH THE HANDLE. REPOSITION
THE HANDLE ON THE OUTSIDE AND TIGHTEN USING THE PROVIDED SCREWS.
ASSEMBLY COMPLETE.