modway Allegory EEI-2550 User manual

Back Legs ×2 Chair Body ×1
Front Legs ×2
EEI-2550 LEISURE CHAIR
Bolt M8×100mm ×8
E
Spring Washer M8 ×8
Flat Washer M8 ×8
LEISURE CHAIR
leisure chair
Adjustable Glide×2
(Remarks: 2 pcs for backup use only)
and then follow the simple step-by-step
f reach of children.

EEI-2550 LEISURE CHAIR
A×4 B×4 C×4
A×4 B×4 C×4
Legs Package
+
Hardware Package
Insert 1 piece of Back Leg (2) with 2 pieces of Bolt (A), 2 pieces of Spring Washer (B), and 2 pieces
of Flat Washer (C) into the bottom of Chair Body (3) as shown.
Repeat the same steps for another Back Leg (2).
Do not fully tighten Bolts (A) for either leg.
STEP2:
D×1
D×1
insert
bolt from
this side
(1)
(1)
insert
bolt from
this side
(1)
(2)
(1)
(2)
STEP1: Please open the Velcro on the bottom of Chair Body (3) and take the legs and hardware from package on
the bottom of Chair Body (3). There are numbers shown on legs and each corner of the bottom of Chair
body (3). Please match them correctly. Attention the label '' Insert bolt from this side'' on the legs and insert
the legs at correct side.
Insert 1 piece of Front Leg (1) with 2 pieces of Bolt (A), 2 pieces of Spring Washer (B), and 2 pieces of Flat
Washer (C) into the bottom of Chair Body (3) as shown. Repeat the same steps for other Front Leg (1).
Do not fully tighten Bolts (A) for either leg.

EEI-2550 LEISURE CHAIR
E×2
STEP3: Please adjust the Adjustable Glide (E) on the bottom of the Back Legs (2) and balance the chair
for uneven floor.
STEP4: Fully tighten all Bolts (A) with Allen Wrench (D).
Recover the Velcro on the bottom of Chair Body (3).
Carefully turn over the chair .
Assembly is completed. The chair is ready to use now!
E