modway EEI-3942-WHI User manual

Thank you for purchasing the MODWAY Vanity!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions.
2.Owing to the size and weight of the vanity, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 60 minutes.
3.Please do not use any tools other than those provide or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.

Hardware required. Hammer not included
Hardware required. Screwdriver not included
Carefully insert the Wood Dowels (A) at the designated holes on the relevant parts.
Use Philips screwdriver to insert the Cambolt (B) carefully at the designated holes on the relevant parts.
Please ensure the Cambolt is inserted and secured at the correct pre-drilled holes.
(Power tool not recommended)

Hardware required. Screwdriver not included
Hardware required. Screwdriver not included
Assemble 2 pieces of Door Hinges (G) to the 'Door Left (6)' and 'Door Right (7)' on each sides and secure
it with 2 pieces of Screws (F) for each hinges.
Properly insert the Camlock (C) in the pre-drilled hole then align it to the assembled Cambolt (B) to secure
both Back Panel 1 (4) and Back Panel 2 (5) to the Vertical Panel 3 (14) and Vertical Panel 4 (15).
This assembly namely Back Frame Assembly

Hardware required. Screwdriver not included
5.1- Lay flat the Side Panel Left (1) which already assembled with 8 pieces of Wood Dowel (A) and 2 pieces of
Cambolt (B).
5.2- Properly align the Bottom Panel (3) Wooden Dowels to the pre-drilled hole.
5.3- Once aligned push the Bottom Panel (3) in and align the Camlocks (C) to the Cambolt (B) to secure the
Bottom Panel (3) to the Side Panel Left (1).
6.1- Lay flat the Side Panel Right (2) which already assembled with 8 pieces of Wood Dowel (A) and 2 pieces
of Cambolt (B).
Repeat step 5.2 - 5.3 to secure the Side Panel Right (2) to the Bottom Panel (3).