modway EEI-2142 User manual

EEI-2142 CHAIR/ EEI-3353 LOVESEAT
Customer Service 908-368-1025︱www.modway.com
Page 1 of 2
Thank you for purchasing the MDOWAY Chair/Loveseat.
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the table/loveseat, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x75mm x8
Flat Washer x8
1. Chair Body x1 2. Leg x4
A.
C.
Allen Wrench x1
D.
Spring Washer x8
B.
1
2
2
2
2
EEI-2142 Chair
EEI-3353 Loveseat

EEI-2142 CHAIR/ EEI-3353 LOVESEAT
Customer Service 908-368-1025︱www.modway.com
Page 2 of 2
STEP 1 :
Please put the Chair Body (1) upside down on a carpeted or padded area by two adults.
Open the Zipper on the bottom of chair Body (1) as shown.
Take out the 4 pieces of Legs (2) and hardware package on bottom of the Chair Body (1).
Attach 1 piece of Leg (2) to the bottom of Chair Body (1) by using 2 pieces of Bolts (A) with 2 pieces of Spring
Washers (B) and 2 pieces of Flat Washers (C) as shown.
Repeat the same steps for other 3 pieces of Leg (2).
Tighten Bolts (A) by using Allen Wrench (D) as shown.
STEP 2:
Close the zipper on the bottom of the Chair Body (1).
Carefully turn over the assembled Chair Body (1) and Legs (2) from step 1 as shown.
Assembly is complete. Your Chair is ready to enjoy now!