modway EEI-2701 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI–2701 DINING CHAIR
Hardware:
Component:
A Bolt M6x60mm x 8
1
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
B Allen Wrench M4 x 1
2
3
4
Chair Back x1 2 Chair Seat x1 3 Left Frame x1
1
4 Right Frame x1 5 Seat Cushion x1
5

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI–2701 DINING CHAIR
STEP 1:
STEP 2:
Please put Left Frame (3) on a carpeted or padded area.
Place Chair Seat (2) close to Left Frame (3) as shown.
Insert 2 pieces of Bolt (A) into the pre-drilled holes on Chair Seat (2) through the pre-drilled holes on Left Frame (3).
Use Allen Wrench (B) to tighten Bolts (A).
Repeat the same step for Right Frame (4).
Do not fully tighten Bolts (A) at this step.
Put Chair Back (1) to the assembled Left Frame (3), Chair Seat (2) and Right Frame (4) as shown.
Insert 2 pieces of Bolt (A) into the pre-drilled holes on Chair Back (1) through the pre-drilled holes on Left Frame (3).
Repeat the same step for the Right Frame (4).
Use Allen Wrench (B) to tighten all Bolts (A) clockwise until secure .
Ax4 Bx1 Hardware & Tool required
Hardware & Tool required
Ax4 Bx1
B
A
A
A
A
A
4
3
2
3
2
3
4
2
1 1
2
3
4
A
A
A
A
A
A
B
Pre-drilled Holes

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI–2701 DINING CHAIR
STEP 3:
Assembly is complete. Your dining chair is ready to be used now!
Carefully position the assembled dining chair to the desired location.
Put Seat Cushion (5) into the assembled chair.
Tie Seat Cushion (5) to Chair Back (1) by using the banding on the back of Seat Cushion (5) as shown.
5
Banding on the back of seat cushion