modway EEI-2080 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI-2080/2081 CASUAL CHAIR
Hardware:
Component:
1 Chair Body x1
Thank you for purchasing the MODWAY CASUAL CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the bench, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
2 Leg x1
3
3 Leg x1
C Allen Wrench M4 x1
A Bolt M6x12mm x4
B Bolt M6x20mm x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI-2080/2081 CASUAL CHAIR
1
A
A
A
3
3
2
2
C
STEP 1:
Please put Legs (2&3) on a carpeted or padded area as shown.
Attach Leg (3) to Leg (2) by using 1 piece of Bolt (B) as shown
Use Allen Wrench (C) to tighten Bolt (B), do not fully tighten Bolt (B) at this step.
Bx1 Cx1 Hardware & Tool required
STEP 2:
Please put Ottoman Body (1) upside down on a carpeted or padded area.
Insert the bended end of assembled Legs (2&3) into the pre-installed post at the back corner of the bottom of Chair Body (1).
Insert the straight end of assembled Legs (2&3) into the pre-installed post at the front corner of the bottom of Chair Body (1).
Attach by using 4 pieces of Bolt (A) as shown.
Use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
Ax4 Cx1 Hardware & Tool required
2
3
B
C
A
Note: Please insert the bended end
of Legs (2&3) into the post at the
back corners on the bottom of Chair
Body (1) firstly at this step.

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI-2080/2081 CASUAL CHAIR
STEP 3:
Assembly is completed. The chair is ready to enjoy now!
Carefully turn over the assembled chair.