modway EEI-2266 User manual

Customer Service 609-256-9000︱www.modway.com Page 1 of 2
EEI-2266 ARM CHAIR
Hardware:
Component:
ABolt M6x20mm x4
B
CAllen Wrench M4 x1
1Top Rail x1
Thank you for purchasing the MODWAY ARM CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2
1
Bolt M6x25mm x6
3
4
2 Left Leg x1 3 Right Leg x1
6
5
4Seat Frame x1 5 Seat Cushion x1 6 Back Cushion x1

Customer Service 609-256-9000︱www.modway.com Page 2 of 2
EEI-2266 ARM CHAIR
STEP 1:
Remove the plastic covers which pre-install in the end of the Seat Frame (4) by using Allen Wrench (C).
Please put Left Leg (2) on a carpeted or padded area as shown.
Insert Top Rail (1) and Seat Frame (4) into Left Leg (2) as shown.
Insert 3 pieces of Bolts (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of Left Leg (2).
Insert 2 pieces of Bolts (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of Left Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for Right Leg (3).
After checking the leveling for all connections, please use Allen Wrench (C) to tighten all Bolts (A&B) clockwise until secure.
STEP 2:
Assembly is completed. The chair is ready to enjoy now!
Carefully place the assembled chair at your desired location.
Put the Seat Cushion (5) and Back Cushion (6) to assembled loveseat frame as shown.
5
6