modway EEI-1045 User manual

EEI-1045 CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 1 of 3
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted
or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
Hardware:
Components:
Bolt M8x65mm x8
Flat Washer x6
1. Seat x1 2. Right Armrest x1 3. Left Armrest x1 4. Back x1
A.
C.
Allen Wrench x1
B.

EEI-1045 CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 2 of 3
STEP 1:
1. Please put Seat (1) stand upright down on a carpeted or padded surface as shown.
3. Attach the Left Armrest (2)to the left of the Seat (1) by using 2 pieces of Bolts (A) with 2 pieces of
Flat Washers (B) and use Allen Wrench (C) to tighten Bolts (A) clockwise as shown.
Don’t fully tight Bolts (A) at this step.
STEP 2:
Attach the Right Armrest (3) to the right of the Seat (1) by using 2 pieces of Bolts (A) with 2 pieces of
Flat Washers (B) and use Allen Wrench (C) to tighten Bolts (A) clockwise as shown.
Don’t fully tight Bolts (A) at this step.

EEI-1045 CHAIR
Customer Service 609-256-9000︱www.modway.com
Page 3 of 3
STEP 3:
1. Open the HOOK & LOOP on the fabric cover of the Back (4) as shown.
2. Attach the Back (4) to the back of the Seat (1) by using 2 pieces of Bolts (A) with 2 pieces of
Flat Washers (B) and use Allen Wrench (C) to tighten Bolts (A) clockwise as shown.
Don’t fully tight Bolts (A).
3. Insert 2 pieces of Bolts (A) and 2 pieces of Flat Washer (B) to the bottom of Seat (1) as shown and use
Allen Wrench (C) to tighten Bolts (A) clockwise as shown. Don’t fully tight Bolts (A).
4. When all parts are fixed, please fully tighten all Bolts (A) and close the HOOK & LOOP on the fabric cover
of the Back (4).
Assembly is complete. Your Chair is ready to enjoy now!