modway EEI-2668 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2668/2669 TABLE
Hardware:
Component:
A
1 Table Top x1
Thank you for purchasing the MODWAY TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all fitting out of reach of children.
1
2 Table Leg x4
2
Bolt M8x80mm x8
B Spring Washer M8 x8
C
D
Flat Washer M8 x8
Allen Wrench M5 x1
2
2
2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2668/2669 TABLE
STEP 1:
Hardware & Tool required
STEP 2:
Assembly is complete. Your table is ready to be used now!
Carefully turn over the assembled table.
Please put Table Top (1) upside down on a carpeted or padded area.
Position 1 piece of Table Leg (2) to the bottom of Table Top (1) as shown.
Insert 2 pieces of Bolt (A) with 2 pieces of Spring Washer (B) and 2 pieces of Flat Washer (C) into the holes on bottom of
Table Leg (2) through the holes on Table Top (1).
Repeat the same steps for the remaining Table Legs (2).
Use Allen Wrench (D) to tighten Bolt (A) clockwise until secure.
A
Ax8 Bx8 Cx8 Dx1
B
C
D
C
C
B
C
B
B
A
A
A
1
2
2
2
2