modway EEI-2639 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 3
EEI-2639 TABLE
Hardware:
Component:
A Bolt M8x20mm x8
1 Table Top x1
Thank you for purchasing the MODWAY TABLE！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
2 Table Leg x2
D
B
1
2
2 3
3 X Rail x1
E
Nut M8 x5
Allen Wrench M5 x1
Bolt M8x25mm x1
C Flat Washer M8 x10
F Open Wrench x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 3
EEI-2639 TABLE
STEP 1:
Ax4 Ex1 Cx4 Hardware & Tool required
STEP 2:
Please put Table Top (1) upside down on a carpeted or padded area.
Insert Table Legs (2) into the bottom of Table Top (1) as shown.
Insert 4 pieces of Bolt (A) with 4 pieces of Flat Washer (C) into the pre-drilled holes on Table Top (1) to secure Table Legs (2).
Use Allen Wrench (E) to tighten Bolts (A). Do not fully tighten Bolts (A) at this step.
Hardware & Tool required
2
A A
1
E
A
Ax4 Bx1 Ex1 Dx5 Cx6 Fx1
2
A
2 C
D
1
D
A
B
C
A
D
A
D
2
C
C
D
C E
A
Position X Rail (3) to the assembled Table Top (1) and Table Legs (2) as shown.
Insert 4 pieces of Bolt (A) with 4 pieces of Flat Washer (C) into the pre-drilled holes on Table Legs (2) through the pre-drilled
holes on X Rail (3).
Insert 1 piece of Bolt (B) with 2 pieces of Flat Washer (C) into the pre-drilled holes on the middle of X Rail (3).
Secure all Bolts (A&B) by using 5 pieces of Nuts (D).
Use Allen Wrench (E) and Open Wrench (F) to tighten Bolts (A&B) and Nuts (D) until secure.
Use Allen Wrench (E) to tighten all Bolts (A) clockwise until secure.
3
F
C
C
C C

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 3
EEI-2639 TABLE
STEP 3:
Assembly is complete. Your table is ready to be used now!
Carefully turn over the assembled table.