modway EEI-2704 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 4
EEI–2704 3 PIECES OF SIDE TABLE
Hardware:
Component for each large/medial/small side table:
A Bolt M6x50mm x18
1
Large/medial/Small Table Top x1
Thank you for purchasing the MODWAY SIDE TABLE!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the side table, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
B Allen Wrench M4 x1
3
2
1 2 Large/medial/Small Left Frame x1
4
Large side table Medial side table
Small side table
Large/medial/Small Right Frame x1
3 4 Large/medial/Small Stretcher x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 4
EEI–2704 3 PIECES OF SIDE TABLE
STEP 1:
STEP 2:
Please put Large Left Frame (2) on a carpeted or padded area.
Insert the tenon on Large Table Top (1) into the rabbet on the Large Left Frame (2) at first.
Then insert the tenon on Large Stretcher (4) into the rabbet on the Large Left Frame (2) as shown.
Carefully position the assembled Large Table Top (1), Large Left Frame (2) and Large Right Frame (3) as shown.
Insert the tenon on Large Table Top (1) and Large Stretcher (4) into the rabbet on the other Large Right Frame (3).
2
1
2
1 3
4
4

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 4
EEI–2704 3 PIECES OF SIDE TABLE
STEP 3:
Insert 4 pieces of Bolt (A) into pre-drilled holes on Large Table Top (1) through the pre-drilled holes on Large Side Frames (2/3).
Insert 2 pieces of Bolt (A) into pre-drilled holes on Large Stretcher (3) through the pre-drilled holes on Large Side Frames (2/3).
Use Allen Wrench (B) to tighten all the Bolts (A) clockwise until secure.
Hardware & Tool required
Ax6 Bx1
Repeat the same steps for Media Side Table and Small side Table.
STEP 4:
A
A
A
A
2
3
1
A
B
4
Medial Side Table Small Side Table
Hardware & Tool required
Ax12 Bx1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 4 of 4
EEI–2704 3 PIECES OF SIDE TABLE
Assembly is complete. Your side tables is ready to be used now!
Carefully position the assembled side tables to the desired location.
STEP 5: