modway EEI-3689-NAT-TAU User manual

AScrew M6x70mm x 6
2. Leg Frame 2
3. Back Rail 1
x1
EEI-3689-NAT-TAU CHAIR
Hardware:
Component:
Page 1 of 3
Thank you for purchasing the MODWAY CHAIR!
Before you start, here are some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of children.
Customer Service 609-256-9000 www.modway.com
1. Leg Frame 1 x1
12
3
4
4. Back Rail 2
B
5
5. Seat
x1
x3
x1
6. Seat Cusion x1
6
BAllen Wrench M4 x 2

Attach Leg frame 1 (1) to Seat (5) ,Back Rail 1 (3). Then insert 3 pieces of Screws (A) through Leg Frame 1 (1)
into Seat (5) ,Back Rail 1 (3). Use Allen Wrench (B) to tignten Screws (A).
x3
A
EEI-3689-NAT-TAU CHAIR
Page 2 of 3
STEP 1:
Hardware & Tool required
Hardware & Tool required
Customer Service 609-256-9000 www.modway.com
STEP 2:
3
x1
B
B
A
5
1
B
A
x3
A
x1
B
Attach Back Rail 2 (4) first to the Leg Frame 1 (1) as shown then attach Leg Frame 2 (2) to the assembled Seat (5),
Leg Frame 1 (2), Back Rail 1 (3) and Back Rail 2 (4) as shown. Then insert 3 pieces of Screws (A) through Leg
Frame 2 (2) into Seat (5), Back Rail 1 (3). Use Allen Wrench (B) to tighten Screws (A).
3
4
2
5

EEI-3689-NAT-TAU CHAIR
Page 3 of 3
STEP 3:
Customer Service 609-256-9000 www.modway.com
6
Assembly is complete. Your chair is ready to enjoy now!
Carefully position the assembled chair to the desired location.
Put the Seat Cushion (6) into the assembled chair as shown.