modway MOD-6268 User manual

Thank you for purchasing the MODWAY BED!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step instructions.
2. Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approximate assembly time: 35 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save tools that have been provided.
6. Please keep all fitting out of reach of children.
Hardware:
1
2
WOOD SCREW M3.5 x 16mm 4 PCS
3
PVC BLACK WASHER 4 PCS
4
BED SLAT SIDE FITTER 24 PCS
M5 ALLEN KEY (BALL SHAPE) 1 PC
Component:
A. HEADBOARD
C. SIDE RAIL (L/R)
D.
E.
F.
CENTER RAIL SUPPORT
BED SLAT
BED LEG
01 of 04
MOD - 6268
x 1
x 2
x 1
x 12
x 4
B. FOOTBOARD x 1
E
A
B
C
F
D

STEP 1
02 of 04
1.1 Insert and secure the Bed Leg (F) to the Headboard (A) and Footboard (B) using hardware
parts PVC Black Washer (2).
STEP 2
F
2
A
B
2. PVC BLACK WASHER x 4pcs
2.1 Loosen the pre-inserted bolt on the Headboard (A) & Footboard (B) using hardware part
Allen Key (4).
4
A
B
4. M5 ALLEN KEY (BALL SHAPE) x 1pcs
MOD - 6268

STEP 3
03 of 04
1. WOOD SCREW M3.5 x 16mm x 4pcs
STEP 4
A
C
3.1 Attach the Side Rails (C) to the Headboard (A) & Footboard (B) using hardware part
Allen Key (4).
C
A
B
Screw Driver
D
C
1
4.1 Insert and secure the Center Rail Support (D) to the Side Rail (C) using hardware parts
Wood Screw (1).
D
C
A
B
4
4. M5 ALLEN KEY (BALL SHAPE) x 1pcs
MOD - 6268

STEP 5
04 of 04
6.1 Carefully position the assembled bed to the desired location by four adults.
3. BED SLAT SIDE FITTER x 24pcs
5.1 Insert the Slats (E) into the end Slat Cap (3) and fix it to the corresponding holes on
the Side Rail (C).3
E
STEP 6
Assembly is complete. The bed is ready to use now!
NOTE: Hardware may loosen over time. Periodically check that all connections are tight.
Palm
E
3
MOD - 6268