modway EEI-2084 User manual

Customer Service 908-368-1025︱www.modwayfurniture.com Page 1 of 2
EEI-2084 CASUAL CHAIR
Hardware:
Component:
1
2 Allen Wrench M5 x1
A Right Leg x1
Thank you for purchasing the MODWAY CASUAL CHAIR！
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or
padded area, in the room that it is intended for. Approx assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or the instruction until you have checked all the components and
hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
environmentally friendly way.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that has been provided.
6.Please keep all fitting out of reach of children.
A
Bolt M8x20mm x8
B Left Leg x1
D
C
B
C Chair Seat x1 D Chair Back x1

Customer Service 908-368-1025︱www.modwayfurniture.com Page 2 of 2
EEI-2084 CASUAL CHAIR
STEP 1:
1x2pcs 2x1pc Hardware & Tool required
STEP 2:
1
C
A
Back
Two People are recommended for this step.
Attach Left Leg (B) to Chair Seat (C) by using 4 pieces of Bolt (1) as shown.
Use Allen Wrench (2) to tighten Bolts (1), please do not fully tighten Bolts (1) at this step either.
Please put Right Leg (A) side down on a carpeted or padded area.
Attach on side of Chair Seat (C) to Right Leg (A) by using 4 pieces of Bolt (1) as shown.
Use Allen Wrench (2) to tighten Bolts (1), please do not fully tighten Bolts (1) at this step.
1x2pcs 2x1pc Hardware & Tool required
2
Front
A
C
B
Back
Front
1
1
1
2

Customer Service 908-368-1025︱www.modwayfurniture.com Page 3 of 2
EEI-2084 CASUAL CHAIR
STEP 3:
1x4pcs 2x1pc Hardware & Tool required
STEP 4:
1
Two People are recommended for this step.
Carefully turn over the assembled Legs (A&B) and Chair Seat (C).
Attach Chair Back to Legs (A&B) by using 4 pieces of Bolt (1) as shown.
Use Allen Wrench (2) to tighten Bolts (1) and the Bolts (1) at step 1 and step 2 clockwise until secure.
2
D
A
B
Place the assembled chair to your desired position.
Assembly is complete. Your chair is ready to be enjoyed now!
1 1
1